Your cart is empty.
Your cart is empty.
-Type: Tapered angle Ball Nose End Mill / Cone Cutters
-Flutes: 2 Flutes
-Tip Radius: 0.25mm
-Shank Diameter: 1/4"((d1)
-Cutting Length: 1-1/4"(L1)
-Overall Length: 3"(L)
-Single side angle B=5.26°(Approx.)
-Coating: TiAIN
-Material: imported tungsten carbide
-Suitable For:Cutting, end milling, slotting on: aluminum, solid wood,partical board,Hard wood, plywood, etc; -Use top quality imported tungsten steel carbide -Excellent chip removal effect! -High surface finish, excellent work -Long service life
April WNolen
August 18, 2025
I use this bit for my cnc. It works well on black walnut
john digi
July 26, 2025
It cuts through maple wood with ease. Used it to make a design on wood. Very pleased with results .
Charles Darwin
July 19, 2025
I've used this for very fine finish pass carving and it works quite well.
Jeff Lovvorn
June 28, 2025
Came from recommendation online. Makes MUCH cleaner cuts and allows for deeper cuts for engraving work in wood.
Andrew M.
June 26, 2025
As another reviewer noted, excellent performance on CNC engraving in aluminum. Cuts relatively clean, with few burrs, at depths up to 0.020" (in 2 passes). Only improvement would be to optimize the grind of the bit shorten the taper so that the bit could be double ended and stiffer. As it is the bit has a very long taper and that makes for some whip. I do like the narrow end for nice, deep, lettering.
RIRE
January 28, 2025
This is not 6 bad bit but if you do a lot of 3D/2.5 carving you will be better off with a more expensive one (amana). After let's say 10 carvings the bit gets doll and the color, you can't call this a coating, is gone. That's not a problem but a doll bit is not useful for anyone. So not bad for the price but if you do more 3D than step up to a better bit.
BuckBran
January 4, 2025
Worked great. I don’t know if it’s meant to be used in a hand held router or not but I was making a something that was pretty detailed so I needed a very fine tip and this worked perfectly.
slumpkin
November 20, 2024
I use this bit to put my name and personal art on my AR builds. The lettering in the pic of my name is 2.5mm high, the pin at lower right is 4mm (5/32") for comparison. I bought three bits, and am still using the first one after 2 builds which also have drawings on the magazine well (Second Pic).
Recommended Products
