Your cart is empty.
Your cart is empty. The bantam plastic anchor is intended for light duty, non-critical applications. It can be used with a variety of foundation materials, including concrete, block, and brick. Although it is possible to use in wallboard, the holding values may vary and be unpredictable depending on the application. These anchors should not be used in overhead applications or in situations where holding values are crucial.
Kit includes：
(100) #10-12 anchors
(100) #10 x 1" Screws
(1) 1/4" carbide drill bit
Installation Instructions:
Using the provided drill bit, make a hole in the base to a depth of at least 1/4" deeper than the required embedment.
Clean the hole of dust and other material, blowing away as much as possible.
Tap the anchor into the hole so it is flush with the base material surface.
Position the fixture and insert the screw through the fixture to the top of the anchor and tighten.
Check that the screw thread fully catches the anchor body and that the anchor does not spin.
Steve
2025-07-21 16:36:57
Came with the matching drill bit which helps make installation easy
SJB
2025-07-06 10:50:43
I bought these anchors after I tried to install a baseboard cover with the supplied hardware, their anchors just spun freely in the wall-cheap junk. I have used these blue anchors in bathroom tile and sheet rock, both installations are rock solid! do yourself a favor and buy these now so you always have them on hand.It also comes with the proper sized drill bit. can't go wrong.
Customer
2025-07-02 14:56:12
Great kit, used them in block and brick. Nice and sturdy.
Steve M
2025-04-30 12:29:23
Would have worked fine except the screw heads were a little oversized for my needs. Probably my fault not theirs.
Ginger H
2025-04-10 09:41:55
We use a lot of these and send them out with crews. This packaging allows me to give them a kit with all that is needed at a more economical price.
reviewers name
2025-03-16 09:27:33
Tired of paying Dottie's (brand) high prices, so I switched to these. Same performance. The #6 version does come with correctly sized 3/16" bit.
Joe
2025-03-01 15:19:53
I installed a US flag on the front of our house. Easy to use and holds just fine.
Mark J. Janowicz
2024-12-30 11:46:22
No problems at all
Recommended Products
