Your cart is empty.
Your cart is empty.INDUSTRIAL AND HYDRAULIC IS OUR SPECIALTY, NOTHING ELSE....! Non-marring wheels leave no marking on your surfaces. Brand New Set consists of: 1 x Pair Load Wheels Poly Tread complete with Bearings, Axles & accessories. This is specific set fit Crown manual pallet jack PTH50, This is GENERIC PARTS
Keith T.
August 25, 2025
These rollers fit like the original rollers on my Crown PTH pallet jack. Easy install, punch out two roll pins per roller and knock out the axel and install the new roller, axel, roll pins in reverse order. The kit comes with everything you need. I did have to widen the mounts and use bolts that were 1/4" longer for the little orange rollers to fit as they were a bit wider than the originals.
Richard
August 4, 2025
It fit like a glove and went together quick
Kris B.
July 26, 2025
These appear to be decent wheels to replace the ones that are shot on our jacks at work. I have learned over the years to just buy the axles along with the wheels and bearings because you will most likely have to beat the crap out of the old ones to get them off. These wheels have a bit smaller diameter than the original crown wheels and are a bit narrower but they fit on fine and seem to be working great. It is a cheap and easy fix to make you jacks pull like new again.
Customer
June 25, 2025
Our Crown pallet jack was useless. The front load wheels had disintergrated. The new replacement wheel kit turned a pile of scrap metal into a "like new" pallet jack for 10% of the cost of a new unit! Great product!
Weasel
April 23, 2025
Easy install, fits correctly
Biff Buffington
February 4, 2025
If you work on equipment and have the right tools, it's simple replacement.
Ashley Taylor
December 22, 2024
Since pallet jacks are on back order for most companies my jack needed new wheels so I brought this and it was great. It came with both front wheels and the bearings.
Jordan
November 20, 2024
These were a direct replacement on our pallet jack. They are very smooth and quiet. They are an ever so slightly smaller diameter so the jack sometimes scrapes thefloor when fully down. This isn't an issue as it only takes about a 1/10 pump to raise the forks off the floor.
Recommended Products
$113.99
$ 48 .99 $48.99