Your cart is empty.
Your cart is empty.Daystar Comfort Ride 1" Front Strut Spacer Kits are designed to improve ground clearance, allow use of large tires and enhance the performance of the vehicle. They are made from high density polyurethane that ensures long lasting durability. These kits facilitate easy installation.
Daniel
2025-08-20 21:22:54
Had these installed on my 99 Tacoma a year and half ago and they work great . they gave me just enough lift in the front to accommodate 31" tires and they have held up to the driving conditions I have put them through..off-roading... I go through quite the gantlet to reach my property on the weekends.... and have fun doing it ..
Brian
2025-08-12 10:57:28
I used this on a 2005 Tundra extended cab 4x4 and it lifted the front end about 1 1/2". That is just what I was looking for (level). The kit doesn't have new studs as pictured and uses stud extenders which requires cutting about 1/4" off the existing 3 studs on the top of each spring/shock assembly. If you don't do this initially, you'll be doing it later to make it right... (Don't ask how I know this)It also requires a spring compressor set to facilitate removal of the spring shock assembly. You can usually rent those from a local parts store. And finally, I had an upper ball joint which wouldn't respond to the hammer method of separating. I bought a GearWrench 3916D Universal Ball Joint Separator on Amazon $29 and it made the job easy.
Matthew Yepes
2025-07-21 11:22:21
Paired with moog 81041 and 81088 coils for about 3" of lift. Wasn't that hard to install. Rides just as good as stock. Done a few 4x4 activities and no problems so far while wheelin. The coil and spacer combo would fit 33" tires no problem.
Koditten
2025-05-22 10:23:57
I was a little disappointed to find that there were no nuts included with the kit. The picture in the add shows nut as part of the kit.I bought this kit primarily for this reason, as I destroyed my originals during disassembly.
The Doctor
2025-04-15 13:25:32
Easy to install, created a slight lift that was needed. Seems to be pretty stable and was cheap.
Nicole Hyer
2025-03-27 14:18:12
It’s definitely 1†thick but it gives the vehicle more than one inch of lift due to the suspensions design. Wish I knew this before ordering. It gave my 4runner just under 2†of over all lift in the front end measured at the wheel wells. Much higher than I anticipated when buying a 1†lift spacer...
Joe Y
2025-03-06 14:26:34
Easy to install and came with hardware to extend the top of the strut mounting bolts. Adds more that 1†due to suspension geometry. It leveled my 2000 tundra to the stock rear perfectly. This kit with minor trimming and 2†wheel spacers clears 33s for me without rub.
Wesley
2025-02-02 15:57:36
Easy to install. Straight forward. Gave me 1.25-1.5 inches of lift up front. Could vary based off weight up front. I’m also 2WD. Some factors to consider: spacer lifts aren’t 1/1 . Usually they are 2/1.. so if you want an inch lift, you need a half inch spacer
paul
2025-01-31 17:05:47
Good product fast delivery A+
abraham roxas
2024-12-23 16:32:04
Fit good
Jody Derocher
2024-12-14 15:17:40
Did not fit
Recommended Products
$179.95
$ 83 .99 $83.99