Your cart is empty.
Your cart is empty.Denso 478-1500 Receiver Drier
Casey V
August 28, 2025
This was the original silicate that was installed in my OEM condenser and so it fit perfectly and works great, value for what you get is not bad at all.
Matthew Curry
July 13, 2025
Exact and perfect fit for my 2007 Corolla
Hallo
June 13, 2025
2010 Toyota Camry SE with 2ARFE engine, 6 spd AT. Same fit. The new replacement filter is slightly wider but it goes in and out just fine. You'll need a special to tool to unbolt the old. Do not over tighten. And you'll need to pull vacuum until the low side is reading ~28in/hg on negative red side. Both sides must be opened when pulling vacuum otherwise your brand new dryer goes bad again. Taking out is not hard but you need to remove a lot of stuff until the condenser is freed from radiator. I had to change out the compressor so I took out condenser. However, if this is your regular MX you can get way with removing 6x 10mm radiator support, remove 2x 12mm horn, then 4x 10mm condenser to radiator bolts. Now you have direct access to remove condenser by crawling under the vehicle.
FeelingGood
June 7, 2025
Get this if you need to work on your AC, worked great for 2004 Toyota Sienna. Got this with a new Denso Compressor. Still working good after way past a year. The old one removed was so soaked with grayish dirt and very wet. ( If I service the AC in a few years I will change this again, since the drier was so soaked and dirty.)
Wilfredo A.
May 12, 2025
ðŸ‘
Excelent case
May 10, 2025
Very good easy isntalation
Fixin-to
April 25, 2025
I originally purchased the Chinese dryer because it was prime. Unfortunately it did not fit so I ordered this one and it fit perfectly. Also the Chinese dryer desiccant came in an unsealed bag. Since it is a third party seller and not prime it took 3 days to receive (better than I etimated) but my car was down for the duration. The dryer is located in the condenser on the driver's side. I was able to install this on my RX from underneath without removing the condenser. Remove the two brackets on the bottom and you can get the plug out using a 14mm hex (allen). The desiccant bag is then removed using long needle nose pliers.
Fred
April 10, 2025
Fit perfect. It came with 2 different caps (one plastic one aluminum). My car uses the plastic one. When I removed the old one, it was black and had oil in it. The new one was white and clean.
Octavio S.
April 8, 2025
Excelente
Rob
March 11, 2025
Worked well
Customer
February 7, 2025
Great fit. Made by Denso so it was expected. Good shipper.
Derek
January 27, 2025
For 2004 toyota echo. I ordered this along with a condenser not knowing it already had one installed. However it was tiny and cheap looking so I'm very glad I purchased this as well for better ac performance
QualityOnly
December 29, 2024
Perfect Fit.
Recommended Products
