Your cart is empty.
Your cart is empty.Product Description
Kit Includes:
- 2x Front Sway Bar/ Stabilizer Links Set– K90344
- 2x Rear Sway Bar/ Stabilizer Links Set– K90345
Fitment:
- Replacement for 2002-2003 Lexus ES300
- Replacement for 2004-2006 Lexus ES330
- Replacement for 2004-2006 Lexus RX330
- Replacement for 2007-2009 Lexus RX350
- Replacement for 2006-2008 Lexus RX400h
- Replacement for 2005-2006 Toyota Avalon (Built After 2/06)
- Replacement for 2002-2006 Toyota Camry
- Replacement for 2001-2003 Toyota Highlander (2 Wheel Drive)
- Replacement for 2004-2013 Toyota Highlander
- Replacement for 2004-2008 Toyota Solara
- Replacement for 2009-2016 Toyota Venza
Easy Installation
Detroit Axle control arm is designed to be a direct-fit replacement, easy to install, better driving and serviceability.
Premium Alloy
Premium alloy material makes the control arm highly wear-resistant and anti-rust. At the same time, high rigidity can extend the life of the product.
Enhanced Structural-Strength
High-strength structure can withstand repeated impact loads, making it more stable during operation
High Performance
Detroit Axle suspension kit is OE manufactured to meet expectations for fit, form, and function, offering high quality and great value.
stealth
2025-08-12 15:47:37
The parts arrived ahead of schedule and packaged well. Heavier construction than OEM with service grease fittings.
Joseph
2025-08-04 11:06:05
Went on with no problems. Car runs waaaaaaay better.
kiara hernandez
2025-07-21 13:17:25
Just like the picture they worked very well
dovid shapiro
2025-04-29 13:54:47
So it seems like great quality, comes pre greased, I'm not a professional or anything but I found it easier to get both sides in before you tighten the bolts, as it seems to be tight(which I believe is good). That being said I would recommend after or while tightening the nuts to tighten the grease valve ad that did seem to loosen(as of now I have only done the rear, will update if anything changes) car drove like new with these and new struts.
Dwayne
2025-03-29 13:02:54
Best value out there. Great quality. I use Detroit Axle on ALL my cars. Quick delivery. Key is to buy in kits & save big $$ !!!
Customer
2025-03-04 12:01:33
The 2 rear were nice and stiff however the front 2 were very loose. I had to replace the front 2.
The Farmer
2025-02-25 12:16:07
I put these on my 2004 Camry because the old ones had torn boots. I thought these would be great since they can be greased. Well, that was the first big fail in the design. These have the cheapest, lowest quality grease zerks known to man on them. I tried to put a little grease in all of them before installation because I couldn't tell if they had been greased at the factory. Half of the zerks fell apart when I tried to put grease in them. The one that are 90 degree are the ones falling apart. The threads that hold the zerk into the 90 degree fitting just pull right out. Horrible quality. Had to try to hold the zerk together to put grease into it. The rear ones would not take a drop of grease, so just put them on the car as is.After installation, there was a popping noise from the rear of the car on day two of driving. I suspected the rear sway links since they move anytime the suspension does by design. I tried to grease them again and they took some grease this time. The noise went away. Obviously, the rear links were A: super tight from the factory, and B: had zero grease from the factory. After they loosened up a bit, they took some grease. If I didn't already have them installed on the car, I'd have sent them back. Total garbage. I'm sure I'll be replacing them sooner than I want.
brian sullivan
2024-11-12 17:33:49
Mine came loose after a month. I bought a different set for my camry and it came with locking nuts. Probably going to add/replace with locking nuts so they don't come off :( The grease fittings are so cheap, mine just fell out, not even tightened. And 18mm nuts, had to buy a special wrench just to tighten.
Recommended Products