Your cart is empty.
Your cart is empty.Product Description
ZFE is a company which provides car parts tool, such as polishing pad and buffing machine.
Uniformly distributed particles
ZFE tools have multiple layers of fine industrial diamond particles bonded to the tips that provide longer tool life.
Sales storage box
The PC plastic case is sturdy, drop-resistant and moisture-proof, easy to carry and hang; all parts were in order and the set was complete, well organized to avoid scattered and confusing.
High-quality materials
1/8” diameter rods, compatible with most rotary tools. ZFE tools are excellent for drilling materials up to 1/2” thick.
Hardness
Very suitable for details, cutting, carving, carving, decoration, and finishing work; I work in glass, metal, stone, ceramics, wood, and plastic.
Different Sharp Bits Accessories
30 Style different sharp router bit can reach More Carving, Great for all types of detail work.
Caution: do not dry
Wet drilling only. Diamond coating is very thin.
Start the hole at an angle.
Carefully move the drill around enough to resume the sides of the hole.
STEP 1
Hold down the safety lock and unscrew the interface.
STEP 2
Place the diamond burrs on the interface.
STEP 3
After putting on the grinding needle, tighten the connector. Exercise on waste materials when used for the first time.
Customer
2025-08-23 19:49:35
Some of the thinner bits are obviously more fragile but lots of bits to make whatever happen. I'll probably purchase again when I need to replace some. Pic in the photo was done with these bits. I'm just starting to learn so again, helpful.
John Burke
2025-08-21 14:12:20
You get 3 sets for the same cost as other offerings - what a bargain I purchased 2 sets
Christine A. Smith
2025-08-06 17:44:36
Good for knocking off burrs or maybe engraving something. Price is right but keep in mind they are not heavy weight tools.
Rosemary
2025-05-27 14:06:52
These bits work wonderful and I am very happy with this product
Rob B.
2025-04-14 10:21:22
Not nearly aggressive enough for slate, may be better suited for finishing. Cheap enough to save for the rare time they’d be useful.
Eric C.
2025-02-14 15:30:06
Good bits but not great how I was hoping to use them. I am a cosplayer and was trying to use these with a Dremel to remove imperfections and supports from 3d prints. Unfortunately, the bit clogs up with the filament when it heats up from the friction. You can soak the bits to dissolve the filament, but this is a timely process.
Steven Weishair
2024-12-27 12:06:37
It did ship on time but only a few bits were diamond coated. Most didn't even do anything to my glass projects, also the shaft is not 1/8th inch it is a little larger so it doesn't fit my tool I have. If you make them metric shaft sizes do not even mention the standard size. 13mm and 1/2 are close but not the same, sometimes a 13mm wrench rounds off a bolt that needed a 1/2 or doesn't fit on the bolt. Same with the drill bits and they don't measure at 3mm as said , when I use a caliper it is a 4mm which is why they don't work for the tools
Placeholder
2024-12-10 18:28:43
Â
Recommended Products