Your cart is empty.
Your cart is empty. 1, Working voltage DC 0 to 50V. Maximum total input current 30 Amps. 6 Channels output, each channel maximum output current 10 Amps.
2, Input terminals pitch 7.62mm/0.3 inch, maximum current 30 Amps for per position, wire size 26 to 10 AWG, stripping length 8mm, Metric M3 slotted screw. Support power supply expansion connect to other modules.
3, Output terminals pitch 7.62mm/0.3 inch, wire size 26 to 10 AWG, stripping length 8mm, Metric M3 slotted screw.
4, Rocker switch ON/OFF power output for each channel. With switch power ON LED indication function.
5, High quality fireproof nylon material DIN rail mount carrier (not China low quality carrier), can support width 35mm rail. FR-4 fiberglass dual copper layers PCB.
CMMH
2025-07-29 16:59:02
I purchased this distribution panel to help me power multiple 12V devices from a single USB-PD power supply, to maximize power efficiency. Each rocker switch has a small led to indicate if the power on that port is on or off. They LEDs can be hard to see from an angle since they are on the PCB and other components block their view. From head-on they are easy to see. Of course, the rocker switch position give you another indicator if the circuit is on or off.Often in devices like this, the screw terminals for the wires are second rate. There are nice and sturdy and could fit some decent size wire in them, at least 18awg, perhaps 16awg. For my use case, the switches stay on all of the time unless I need to power cycle on device, and then the rocker switch allows for that. There are terminals on both ends for inlet, or in my case I use the "outlet" (opposite the inlet) for a voltage monitor.
newchel
2025-05-31 17:03:35
Built diy enclosure controls with this for 3d printer.
Bruce P. Smith
2025-04-23 17:46:04
Liked each switch has LED indicator.
Kindle Customer
2025-03-19 13:38:44
Good switch, mounts rail well, good clamp on the wires, satisfying click on switches, each tiny led does the job without being obnoxious.
David X
2025-03-12 19:44:03
Very useful addition to my electronic mock-ups that need several different voltage rates in one project.
royc
2025-01-09 21:40:43
works for me.
Jeremiah Duininck
2024-12-25 11:36:05
I bought this and wired it up very carefully. powered it up and it fried $200 worth of 12v components. after I lost my mind, i took a multi-meter to several of the connections and found a couple were crossed.Cheap junk with little quality control
David C Luedtke
2024-11-17 15:16:57
My power supplies are the same brand so it’s a form of the same board in all voltages.Was look ing a stable format to judge them. Was what I was shopping is all.
Recommended Products
$22.99
$ 11 .99 $11.99
$17.99
$ 8 .99 $8.99