Your cart is empty.
Your cart is empty.Dopro LP Rear Control Plate Switch Plate Cavity Cover For Epi Les Paul Solid Black 1 Ply
John J. Binder
2025-08-27 12:42:24
Quite a few years ago I had replaced all the cream colored plastic pieces front and back on my Black Les Paul Standard with black plastic. Recently the back pot cover plate broke. The replacement I ordered was a perfect fit.
xPhantasMx
2025-08-15 11:58:11
They're fairly cheap looking but fit my 2014 epi lp custom
clifton smith
2025-08-03 14:33:12
Fit perfect
John-Paul Bonansinga
2025-06-28 16:55:23
Good quality, a little polishing will make them shine. Solid product
Harold L. Howard Jr
2025-06-05 17:22:49
Just like the original ones. Fast shipping.
L. Tate
2025-04-22 11:49:36
The quadilateral piece is made of shiny black plastic, is slightly too small for the cavity in my Epi LP, and would leave a gap if installed, so it's going in the trash. I would have preferred something that was slightly textured and exactly fit the cavity. Not recommended.
Rachael Dillman
2025-04-01 21:39:33
I HAVE AN ARCH TOP EPIPHONE LES PAUL WITH A "DW" SERIAL NUMBER, WHICH WAS MADE IN CHINA, NEITHER OF THE TWO ADVERTISED HERE FIT EVEN THOUGH THE DESCRIPTIONS SPECIFICALLY MENTION THE CHINESE MADE MODELS. THEY ARE BOTH TOO SMALL. RIP OFFS NOT WORTH IT
Ry
2025-03-16 16:56:18
Doesn't fit. Waste of time.
Roby
2025-03-02 16:45:03
Didn't fit my vintage v100 afd but did fit my east coast LP...so at least they got used
Dealzz
2025-01-28 16:30:53
I have a China-made Epiphone Les Paul Custom Pro from 2019. The circular cover that I received with this set is the correct size and hole fitting. It is glossy black.However, the other piece for the control section is totally wrong measurement. I wonder what guitar this was based off of because it’s far off. But this is probably my fault as I should have asked for a measurement sheet from the seller. I do however suggest that the seller post a measurement diagram in the listing so that future customers don’t make the same mistake and leave bad ratings. (UPDATE: Looks like they have now attached the measurement drawing, but the numbers shown in the drawing are different from those in the listing description…..)
Jason Turner
2025-01-02 12:31:59
This product may fit your guitar but it wasn’t even close to fitting my lp. Over 1/8th gap around the edges to my guitar cut out. Had to reinstall the ones that came on my guitar.
stephane Dansereau
2024-12-09 09:24:28
Elle ne fite pas sur ma les oaul
Recommended Products
