Your cart is empty.
Your cart is empty.Axle shaft damaged or bearings worn out? This axle shaft directly replaces the original equipment on certain vehicles, complete with all necessary application-specific installation components. This part is compatible with the following vehicles. Before purchasing, enter your vehicle trim in the garage tool to confirm fitment. [Ford Ranger: 1998, 1999, 2000, 2001, 2002, 2003, 2004, 2005, 2006, 2007, 2008, 2009]
Harrison Okabe
2025-08-28 10:11:14
Fits perfectly
miriam fedorchak
2025-08-09 16:46:14
Perfect fit. Put 10k miles on it. So far no problem.
Michael W.
2025-07-24 14:43:45
Repair was pretty easy right-in right-out, did have to use a grinder on the end to get the PIN to fit back in other than that perfect super tight tolerances.
Martin Forget
2025-07-15 13:37:15
Everything fits perfect.
Ty Stanton
2025-06-07 18:51:11
The axle was just what I needed. The bearing was A name brand and fit great. The seal also looked excellent. I recommend using A driver that is the correct size for installing the bearing. The race could be easily damaged if you try to install it with A punch. I turned one out of plastic. Hard wood would also work. The best way to install the wheel studs is with A hydraulic press before installing the axle.
ranger bill
2025-05-16 14:52:50
Worked perfectly on my limited slip 2wd 2002 Ranger with 7.5 inch axle
Sean Clemmons
2025-04-21 17:45:24
Used oversized nuts as spacers to get the studs in. Held one end with pliers then tightened the lug nuts down with an impact wrench to pull them into place.
William brace
2025-01-03 13:47:59
Every time I turn a corner it grinds it should never grind
Recommended Products
$540.00
$ 99 .00 $99.00
$130.58
$ 57 .99 $57.99