Your cart is empty.
Your cart is empty.Replace only the damaged connectors instead of the entire fuel line with these direct-replacement fuel line connectors. Designed for easy installation and a precise fit, they are engineered to withstand extreme underhood conditions.
TZH
2025-05-20 18:52:26
Did receive a credit . But I didnt understand the description. Can only use nylon fuel hose that dorman carries.
E. D. Drennen
2025-04-19 12:59:06
These 'fuel line line adapters' (metric 14mmx1.5 inverted flare tube nuts) connect 5/16" nylon fuel line to the Toyota metric connections. Routing the nylon hose is MUCH easier than bending the original type steel line runs. Some of the pre-bent factory lines are no longer available for my 27 year old Toyota T100.The fittings may be attached to the nylon hose via a very expensive special tool (from Dorman and others) or you can do like me and use a flaring tool tube 'holder' for the nylon line. Simply find the right diameter hole that lightly (but securely) grabs the outside of the nylon hose, place the barbed fitting squarely in the hose and use a simple 'lever-press' arbor to gently press the fitting on. Some recommend immersing the the hose end briefly (seconds) in boiling water and then attempting to 'push' the fitting (by hand) onto the barbed end of the fitting, but that is less than ideal (believe me this old guy tried that).
advance auto
2025-03-10 18:24:39
As described
THOMAS FARKAS
2024-11-21 15:11:48
NOWHERE in the description does it state what the thread size is on the NUT..5/16...8mmNOPE.. it is 14mmx1.5.. DORMAN need to put the BONG Down.
Recommended Products
