Your cart is empty.
Your cart is empty.
Features:
1. Using high-quality materials, the quality is guaranteed
2. The pre-amplifier is designed with two op amps, and one op amp is used for one channel, and the effect is much better than that of a single op amp and two channels.
3. Built-in single power supply to dual power supply chip, so that it has the effect of dual power supply under single power supply
4. Use large-capacity filter capacitors with rectifier circuit, which can be used for both AC and DC
5. Wide range of applications
parameter:
Working voltage: AC5-16V or DC6-24V
PCB size: 50mm*50mm
Overall height of the board: about 23mm
R1, R5 are the magnification setting resistors (the default is about 5 times magnification for delivery, you can change the magnification according to your own needs, the resistance can be selected from 5k-100k, the larger the resistance, the higher the magnification, if you use a plug-in resistor , you can remove the original chip resistor by soldering, and solder the plug-in resistor on the pads at both ends of the patch position)
Package list:
Amplifier board*1
Signal line*2
T. A. Lovern
December 7, 2024
This is a decent little pre-amp board. It is perfect for audio projects. My only complaint is it didn't ship with a data sheet. This is not that uncommon, you can look it up on the internet.
Recommended Products
