Your cart is empty.
Your cart is empty.Wengart combination switch is perfect for any area of the home. Its simple and practical design will help you save space in any area of your home. This switch is sleek and its impact-resistant exterior ensures a long life. This combination decorative switch has a light-colored body that fits into a standard junction box, and it's made of polycarbonate thermoplastic (PCT) material for durability. PCT makes this wall plate resistant up to 140 degrees C, so there's no need to worry about the material melting or fading. This dual switch is easy to install and can replace a regular decorative switch for more control over more appliances. Control lights and fans from the same location. These switches are perfect for turning on ventilation fans and lights separately in the bathroom, or switching cabinet lights and overhead lights separately in the kitchen. Specification:
- Voltage：AC120V-277V
- Current：15A
- Type:Double Paddle Switch
- Terminal:Hot, Load, Ground Terminals
- Wiring:Back Wiring, Use with up to 12AWG
Solobeeper
August 8, 2025
Same as store near by but better price and more quality since individually wrapped no scratches or stain
DIY Guy
July 25, 2025
Two of these were cheaper than one equivalent switch at Home Depot or Lowes. Those stores have lost touch with their prices. They work great and aren’t too loud when you use them.
Roberto Gomez
July 16, 2025
Easy to install, good appearance
Doug
July 11, 2025
Bought these because they were a great value compared to big box stores. They worked out great and I will buy again when needed.
Francisco Munoz
June 16, 2025
Easy to install
Iko
May 28, 2025
Great cheaper replacement.
David L.
April 22, 2025
Replaced double toggle switches with this and it looks so much better. Of course needed new deco plate to accommodate the new switches. Pricing much better than the local outlets near me.
RumGrum2021
February 21, 2025
I'm thinking i might have received a Returned item. Had a weird "burnt" plastic (circuit board) smell. Used one and worked fine. Hooked up a bathroom heat/vent/light combo. One switch i hooked up the vent (to one switch) and light (to other switch).Then installed the other switch on my main bathroom light and wired in the heater portion, that way I don't max out the amperage on one circuit.At first the second install, i had put the "line" to the brass screw and the "loads" to the other switch's (heater and light respectively). Turned on the breaker then one on the switch and both the heater and light came on. It baffled me for a good while. I rechecked all my wiring in the gang box and in the attic for the heat/vent/light combo. All wiring was correct.Then i went out to Lowes to buy another, Eaton, hooked it up and i did the same thing. So i decided to read the instructions very carefully. It stated, "to run the single pole double switch as two INDEPENDANTLY switches, break off the copper tab between the two loads!"That was the KEY! i looked on the Eaton switch and this one and sure enough on the load side, there it was. I took my flathead screwdriver, small, and wedged it in per the instructions and a simple up, down, and back up again then the tab broke off.Now it works fine.How i know this was prob a returned item? The first switch i installed, i didn't have to break the load tabs off because someone else did it for me!They work great now after about 2hrs of troubleshooting, climbing up and down from the attic, turning on and off the breakers to switch the line wires around ect...The single pole 3 switch didn't have the break off tab so idk what gives? It's not like this is or was a 2-way switch configuration.But in the end, lesson learned and experience / wisdom was gained.
David
February 7, 2025
Do Non come with a cover you need to buy separately
Recommended Products
$25.98
$ 12 .99 $12.99