Your cart is empty.
Your cart is empty.Product Description
JD
2025-08-10 17:18:28
Installed one on one of our garage doors. It worked so good I bought another for our 2ed garage door. The seal is thick and is a solid kit. It my require some cutting to get to the proper size for your door but not hard to do.
Honest JohnnyBGood
2025-06-30 10:17:02
Was impressed with the looks and quality of seal. Took about an hour to install but was well worth the time. Was getting lots of dirt,bugs and water before. Now great seal no more worries. Happy to tell others of the of my purchase. Very happy no more gap
Ann
2025-06-22 17:47:30
The media could not be loaded.
Chris M.
2025-06-19 18:27:35
Came 10' as advertised and my door was 9', so of course I had to cut it and all associated parts but that was anticipated. A few cuts with tin snips to go around garage door parts that had to a remain and it installed with relative ease by myself. I read the reviews about kinks in the gasket due to folding in shipping, so I laid it out in the sun for a few days before installing the unit and it worked just fine. Soap the receiver and the gasket edges before installing the gasket in the track and everything worked out well. Very well built unit.
M. Dillon
2025-06-02 13:37:54
Getting that last segment of rubber fit-in wasn't easy, I had to notch one side of the aluminum rail receivers so I could get it in. Can't pre-fit the rubber since that would obscure the screw holes. But its fine, the seals fit my garage door so well at 16.5ft wide that I am really happy with the result!The aluminum pieces screwed in solidly, as-if they were part of the original garage door.I wound up putting the right-angle segment of the aluminum on the outside. I figure that will work better as an ember barrier for fire resiliency, in case an ember sidles up to the bottom of the door.I did forget to put the broom pieces on but that turned out to be just fine... less fire risk without them and the garage door seals well against the wind anyway.-Matt
belzebob
2025-05-17 13:28:32
It was much nicer than I expected.
B. Chapman
2025-02-15 14:16:51
I have rounded top garage doors which makes tolerance near the top tighter than most, but take note these are large seals and may not work if your fitment is tight.I installed and immediately found that I could not use the sweeper as it prevented the door from being able to close. Even removing that I had to trim a lot of wood towards the side as the long rubber seal also jammed until I did so.Once I solved those issues, I found that the way the rubber was shipped folded put several crimps such that, even after having installed for 2 weeks and having my opener compress it a little, water can get under it in one spot where there is a bend that hasn't gone away.I contacted seller and they were immediately helpful sending me rolled rubber seals (without middle reinforcement tube) and another set of the same original seals also rolled but crimped in more places than the original. My end solution may be to use the rolled/uncrimped seals without a reinforcement tube but placing a slice of a pool noodle in there to provide a bit more support than a hollow U channel.Overall I'm a bit torn here; the aluminum rails are good quality (though three pieces) and I like the overall design, but it is bigger than expected so not ideal for my doors and also has a rubber seal that isn't perfect for sealing due to crimping in shipment. The seller was extremely helpful sending replacement rubber so I think I'll end up with something that works but if I had it to do over again I'd probably go for something smaller/thinner
Sergio
2025-01-30 13:55:56
Easy to install and fit my garage door perfectly!
Recommended Products