Your cart is empty.
Your cart is empty.The JGB Enterprises Carboy Brush gets to the bottom and sides of a glass carboy. The bent head of the brush makes short work of cleaning the Kraeusen (foam on top of beer) after fermentation. It is 26" from end of handle to 90 degree bend. Bristles are approximately 1-1/4" in length.
Reader Ruth
September 3, 2025
Very robust but flexible to get through the narrow neck of a large flagon.Delighted with this product that served its purpose well when nothing available locally was big and robust enough for my glass flagon
BrotherDave
April 22, 2025
Sturdy brush, reaches all of 5 gallon carboy with length to spare.
Chris
February 19, 2025
Arrived very quickly. It does work well however, I wish the tip had a few more bristles on it to make scrubbing easier. You can bend the wire a bit so that helps cleaning the inside top area. My mistake was that I left in the cleaning solution filled carboy over night and it rusted.
CoffeeHound
February 13, 2025
Cleaned a very messy carboy after a two week messy fermentation. Good stuff.
bu
February 2, 2025
this brush is able to clean the upper rim easily but a little difficult to clean the sides of the carboy
Peter Rudolph
February 2, 2025
Bought as replacement. Good product.
LUNA
February 1, 2025
I used this to clean out stuck-on apple must from my 5-gallon carboy. I was able to rebend the neck so that I could reach the spots I needed to.
Tallguy
December 24, 2024
Arrived promptly, seems to be decent quality. Have yet to actually use it but fits my 1, 5, and 6 gal. carboys. Probably wouldn't work for anything larger than a 6 gallon carboy.
Recommended Products
