Your cart is empty.
Your cart is empty.Product Description
fitments
fitments
If your factory thread size is different Need to purchase a set of open end lug nuts in the correct thread pitch (your factory thread pitch) to complete the installation
Your Factory wheel studs may extend past the surface of the wheel spacers. In this case you will need to:
1) Shorten the factory studs; 2) The wheels need to have the open slots (cavities) between mounting holes.3) Purchase a set of shorter studs and replace them with the factory studs.
david Baumann
2025-08-24 21:48:11
I got these spacers to run some newer gmc wheels figment was great but I would advise you to not use the spline drive locking lug nuts the studs are to long. If the locking lug nut has an open end on both sides to allow the stud to pass all the way through it. If that makes sense. Otherwise quality spacers for the price.
Andrew carruth
2025-08-13 11:32:20
It work for the truck you will need deep and shallow sockets to put spacers on comes with the red lock tight make sure you use it appropriately, I have towed with it no problems definitely a great buy!
Daniel Moseley
2025-08-07 17:48:49
GOOD QUALITY! BUT you have to Buy smaller lugs the holes that your lugs go through are to small for a 7/8 sockets so you have to get 3/4 Inch lugs
Danil
2025-07-16 16:30:19
Â
Evan Burch
2025-06-30 11:16:45
Came all packaged up very professional! Didn’t have any dislikes about it!
Spider
2025-04-01 12:07:30
High quality material
Darla H.
2025-01-30 11:51:49
Worked exactly like they were supposed to.
Damian
2024-11-26 12:41:37
Would leave zero stars if I could. Only received 2 out of 4 spacers. Tried to contact no response.
Recommended Products