Your cart is empty.
Your cart is empty.Product Description
Electric Hoist Installation Roller for use with 1-5/8" Wide and All 1-5/8" or Taller Strut ChannelTrolley 4 Wheel Trolley Assembly Silent (2Pack)
High-quality replacement part for a quick DIY
- Using Simple: Wheel Trolley For use with 1-5/8" Wide and All 1-5/8" or Taller Strut Channel, Can be used for electric hoist installation,2-way moving installation,Design Load in 700 pound.
- Electric Hoist Installation: the distance from the center of the hole at the bottom of the Strut Channel Trolley can meet the location requirements of the installation hole of different types of electric hoist.
- 2 way moving installation: it can be used in conjunction with the Strut Channel to set up 2 directions of movement so that the Hoist can work in multiple positions.
- High Strength:The pin shaft in the strut channel trolley bearing is made of solid alloy steel, which ensures the high strength of the Wheel trolley.Intermediate support of solid steel, high strength, impact resistance.Galvanized Zinc, rust protection
john hubbard
2025-07-21 15:20:15
great quality
Customer
2025-07-16 10:40:20
was as it said
Michael & Joann Shipman
2025-06-18 11:56:15
Works well, no issues.
Fred
2025-05-21 13:53:07
Love these rollers
Jerry J
2025-05-07 20:50:28
But when you use lag bolts of any significance to keep the strut safely secured to the ceiling joists, the rollers cannot pass the head of the bolts. So I had to removed one bolt from the ceiling, slide the hoist through the strut, then screw in the lag bolt once again. Makes no sense.
Aaron
2025-04-13 12:14:56
Perfectly happy with these and I don't really care what they look like but it shows a bit of lack of care when there are big grinder marks across the product you just got. Besides that though they work great. I've been lifting a tractor auger without issue. The metal is plenty thick and the bearings run smooth. they're sized right for the channel with only a little room side to side for deflection and a bit up and down. Pay no attention to my strut mounting setup; strong enough for what it's for.
Miriam Volle
2025-04-10 11:06:28
These seem well made but are a little rough around the edges - there are burrs and sharp spots on some areas and the bearings are essentially riveted into the trolly - so they can't be changed out or serviced but should work a long time anyway.The cross bars are wide enough to span the width of some of the smaller cable hoists that are readily available - making for a relatively simple to assemble trolly solution for light duty hoisting.Able to just be slipped into a standard strut channel, its a simple solution but you do need stops to prevent it rolling out of the end of the channel.Nice, inexpensive solution.
Norm Doucette
2024-12-31 18:49:05
Works well on my hoist
Recommended Products