Your cart is empty.
Your cart is empty. Color:White (no remote control)
FEATURES
Mini-Tank Water Heater comes with 1.5kW heating element, expect hot water for 3 seconds, perfect choice for sinks to provide endless hot water any time.
ENERGY SAVING
This tankless water heater avoids standby heat loss of those bulky storage water heaters, minimize energy waste and achieve 95% energy saving with help of its smart self adjustment technology.
HEALTHY WATER QUALITY
MULTIPLE SAFETY PROTECTIONS
Over temperature protection
Dry heating protection
Leakage protection
Water and electricity line separated
EASY INSTALLATION
Real compact design, water heater cooridates with scenes decor, under sink water heater, Can be shelf, wall or floor mounted. Comes with easy installation brackets, pipe fitting of 1/2" NPT and 10AWG power cord(fixed to the unit) so you don't to have to hire a plumber even if you can do it.
SPECIFICATIONS
Power: 1.5kW
Voltage: 120V~50Hz
Min. water flow to activate the unit: 0.475GMP
Maximum temperature 167°F
Max. Amperage: 15A
Recommended wire size: 10AWG
Required circuit breaker : 1x1-Pole 20 AMP
KINDLY NOTE
1.The equipment is mainly used for sinks.
2.Mini-tank water heater should be installed professionally.
3.Please read instruction manual carefully prior to installation and use!
Brandalynn Lewis
2025-09-04 09:41:57
I really honestly thought that this wouldn't workWe put this in a RV whose water heater went out and it was too expensive to replace this thing works amazing did exactly what it needed to do and for the right price now you're not going to be taking a 30-minute shower with it but 15 minutes it stays warm
R. Custer
2025-08-21 10:00:51
I usually like to have more experience with this kind of product. Power is temporary and limited amps where this is so I haven't run this full time, but I have run it. It seems to me that it only took 5 to10 minutes to heat from outside winter water to 120°F. That's pretty good for an undersink unit. If I were cleaning paint brushes I would have run out of hot water. But for washing my hands 2.5 gallons is plenty. The instructions are a little confusing, and I am not sure how I feel about the tiny relief valve hose. That said it is a nice looking unit, looks to be high quality. I had none of the leaking problems I see reported here. I am a professional so I used both tape and pipe dope. The temperature was within 5°F of the setpoint. I think that's adequate. I like that the tank is stainless. I would certainly buy from them again.
Tom
2025-06-29 14:28:15
Purchased this water heater for a small office and it worked great! We did have a problem with the unit but the seller took care of it right away! I would recommend this heater to my friends.
Travis M.
2025-06-25 11:14:14
It worked for about 9 months and then went completely dead. No longer heats or lights up at all.
J. S. Radford
2025-05-30 10:04:52
Considering how much pleasure I get from having nice warm/hot water after 4 seconds, I am thinking that of the literally thousands of item I've bought off Amazon over the past 22(!) years, this cute little, perfect water heater might be the best thing of all. Unlikely but may be true.BUT the manufacturer needs to offer HELP! For the subset of buyers like me who have fixtures using 3/8" connectors and not the RV situation.I had a devil of a time figuring out what I needed and then finding parts (see below) and then had a problem after installation as well..................................I installed under house sink connecting to a pull-down faucet ... NOT an RV set-up.Turned out I had 2 problems:1 - I had to search high and low for adapters, since my under-sink water supply to my pull-down faucet used all 3/8" flexible tubing. The correct 3/8"M to 1/2"M to 3/8"F NPS threaded T-adapters, which were NOT included in the kit, were HARD to find.After probably 3+ hours of trying figure out correct threading and configurations and sizes and searching again and again (Amazon search engine SUCKS!!!), I finally found exactly what works: https://www.amazon.com/dp/B0B1F6B39X?psc=1&ref=ppx_yo2ov_dt_b_product_detailsActually I should have simply used a straight NPS 3/8"M to 1/2"M connector for the Hot side since:https://www.amazon.com/PackCompression-Fitting-Reducer-Plumbing-Connector/dp/B0BFL28VCX/ref=sr_1_13?crid=1LQ8UXSSBGHB3&keywords=3%2F8+Male+x+1%2F2+Male+NPS+Adapter+%22not+NPT%22&qid=1678293789&s=hi&sprefix=3%2F8+male+x+1%2F2+male+nps+adapter+not+npt+%2Ctools%2C141&sr=1-13I should NOT have spliced into the Hot faucet from my 40-gallon tank. I did, of course, need a T-adapter for the cold water side so I could still draw Cold water into my faucet.2 - After installation, every time I used the Hot water, I got a "spitting" for 2 seconds then the flow from the new tank. BUT over night, I discovered the Hot water was ice cold despite the new tank registering 102F! Turns out I was NOT drawing from the new tank but from the ice cold feed from my 40-gallon hot water heater! That's exactly what I wanted to avoid: wasting 1.5+ gallons every time I wanted hot water but got ice cold water from the main tank, 20 feet away.After shutting off and thus totally bypassing the Hot water spigot (now connected to nothing!) from the main 40-gallon tank, I ended the spitting and instantly got hot water from under the sink!
Gene
2025-03-20 17:01:38
Good purchase. Heats up fast and gets really hot.
SunnyKitaka
2025-02-17 13:35:01
The first unit developed a slow internal leak. The prompt replacement seems OK>The technical detail is misinformation. It stated Country of Origin: ‎Switzerland but it is made in China.The emergency water outlet is a joke. Although I did not check the prevailing safety code, the failure release valve is very tiny and water ejection tubing is not much greater than 1/4" vinyl tubing. If temperature control malfunctions and the heater stayed on, the internal pressure may bust up the tank and make mess or worse under the sink. The seller, including Amazon should investigate this. I did take this risk, since I got piping done. I can not recommend this to others.
Wings
2025-01-09 19:45:51
I almost put it on the hot side as is typical! The arrow on the valve is barely visible. They don’t explain why it is to be put on the cold side. The directions suck. Better info on the Amazon ad. Dangerous. I question the safety of this.
Recommended Products
