Your cart is empty.
Your cart is empty. Your choice of Alcohol Based Conductive Paint with or without Thinner, Polyurethane Lacquer, or a set! Use to create your own copper electroformed creations. This quick drying paint is great to use for COPPER ELECTROFORMING over organic materials(leaves, acorns, insects, flowers, etc), glass, wax, stones/gemstones, bone, wood, plastic, clay, resin, laser cut and 3-d printed objects, other metals, and more! (basically, if you can paint it, you can electroform it!)
► ► ► ► ► ► ► ► ► ► ► ►
Graphite Conductive Paint for COPPER ELECTROFORMING:
-Alcohol based conductive paint (graphite conductive paint)
-Brush, dip, or spray on
- Can be thinned with 90%+ Isopropyl Alcohol (NOT WATER) if needed
-2 fluid ounce jar
-Wear protective gloves + mask
-Use in a well ventilated area
-Dries instantly, 24 hour cure time is best
-Cleans with Isopropyl Alcohol
Paint Thinner/Brush Cleaner:
-99%+ Isopropyl Alcohol
-Use to lightly thin conductive paint when necessary/needed for airbrush applications*
-2 fluid ounce jar
-Cleans brushes and unwanted paint marks
-Will start out clear, and then with use will be cloudy black
*If used to thin paint, be sure to not over thin your paint! It will decrease conductivity
Polyurethane Lacquer:
-Brush, dip, or spray on
-Seals organics, protects gemstones and crystals
-Wear protective gloves + mask
- 2 fluid ounce jar
-Use in a well ventilated area
-Thin with water if necessary
-Cleans with soap and water
-Dries in an hour, fully cures in 24 hours
Varnish to protect oxidation on finished electroformed copper pieces
techbug
2025-01-24 14:21:54
I applied 3-4 different coats of paint but it won’t conduct electricity at all.
Recommended Products
$164.44
$ 64 .99 $64.99