Your cart is empty.
Your cart is empty.Matt M.
July 29, 2025
Installing this on my 2012 Corvette Z06 was not fun. Beyond that the part works great and seems like a terrific value.
Gail
July 10, 2025
FITS GOOD
Wes Hubbard
June 30, 2025
Worked as advertised to solve 99 psi oil pressure display and engine code.
Teagan S Cobb
May 22, 2025
REVISED: Sensor lasted for 24 hours then went out! Garbage. Get OEM. Don't waste your time!!My P0520 code came on and the oil pressure gauge was stuck at 96 (way too high). Ramped the car up and swapped put the sensor with a 1 1/16 deep socket. Took about 15 minutes. Working well so far. Saved $250 on a mechanic. Thanks!
Steve
May 2, 2025
Performed well
Customer
April 10, 2025
I had gone to several local mechanics and the average estimate was $700 to replace the oil pump on my 07 GMC Sierra 1500 Classic. I wasn't satisfied with the answers I was getting, so I did some searching on YouTube and found out that it was probably the Oil Pressure Sensor; look it up, it may be your issue. So of all the possible vendors, I chose GWA Auto Parts because it looked the most OEM of the choices on Amazon. The repair only took 15 minutes, even though it was done mostly by feel (thanks GM for making it harder than it had to be). I do suggest buying the socket for it; I had to go to my local auto part store for the socket.
P. T. Kreigh
April 8, 2025
Replaced in an '07Corvette. In most cases the sensor is going to be located in the middle, up near the firewall. That requires disconnecting and removing the wiper tray which exposes the cowel you will need to remove (or cut through) to get to the sensor. If you choose the cut-through method, you'll need a hole saw and you'll need a VERY large, deep socket - something like 1 1/16" to fit on the sensor and remove it/install it. A simple device. The question is do you have enough tools+patience+acumen to install it?
Mark L. Smith
February 13, 2025
Not the fault of the sensor, but the little red locking tabs that lock the black locking tab is very hard to press out! However, minimal oil will be lost and you'll need a 27mm open end wrench to get her loose/tight. I put this in a 5.7L Wk2 where I listen to Megadeth on constant loop, Dave Mustaine would approve of this sensor.
Ahmed Alblooshi
November 30, 2024
يتصلون اكثر عن مره يطلبون تقييم التوصيل !!
Recommended Products