Your cart is empty.
Your cart is empty. Advantage:
Made of High Quality Material.
Tested & Certified to Meet or Exceed OEM Quality Standards.
Replace Part Number:
17127531579
Compatible :
2006 BMW 325i E90
2006 BMW 325xi E90
2006 BMW 330xi E90
2008-2013 BMW 128i E82/E88
2006-2011 BMW 323i E90/E91
2007-2013 BMW 328i E90/91/92/93
2009-2013 BMW 328i xDrive E91
2007-2008 BMW 328xi E92
2004-2006 BMW 330i E90
2009-2011 BMW Z4 E89
Warranty:
The Engine Upper Radiator Coolant Water Hose Pipe come with 12 Months Warranty.
hassle-free Return and Refund Policy.
Please Buy it with Your Confidence.
BLUEwarrior333
2025-07-08 19:36:26
Great quality hose! fits right in OEM spot with no fuss or issue! in my opinion it looks and feels better quality then OEM, the one in my car had pinhole so i went looking everywhere! auto parts stores were crazy expensive and some had days to weeks of shipping time or drive a million miles to a sister store, found this cheaper then anywhere and shipping was fast and packaged well! put it on and solved my issue, fitment was perfect and never had an issue! if you're in need this is the one to go for!
328i upper coolant hose
2025-07-01 12:21:08
The hose assembly seems to be good quality and was a perfect fit. Great price, great product!
Cole
2025-06-10 21:56:22
Replaced this along with a few other hoses, so far has lasted about 3k miles. Installation is a little tight but everything fits as it should
StormTrooprSubZ71
2025-05-21 11:58:27
I installed this hose on a E92 08 BMW 328i. My hose was barely leaking but when i tried to remove it it completely snapped off. The remaining plastic piece was stuck on the aluminum tube and had to be cut off. You will have to remove your air box to access the hose. If you have the factory clamp on the small hose just cut off the hose and use a new clamp. Make sure you clean the aluminum tube or else you will not get a good seal. The hose has grooves and will only go in 1 way so make sure you align the grooves. A little bit of grease on the ends allows it to slide right in. After you install it refill your coolant tank with coolant. The hose was very easy to install, it was shipped very fast. The price was the lowest anywhere. The plastic on the BMW factory hoses become brittle after time, if you are replacing 1 hose because of this you should check all your hoses. More than likely you will find other ones that will need to be replaced soon.
Biker
2025-05-01 10:07:56
2006 E90. Leaks from the radiator side and there is no place for the locking bracket to seat into like the original part - see photo.
131 SS
2025-04-20 17:16:57
Good fit and good price.
M. Hosford
2025-03-07 15:25:40
This hose worked just fine, however I feel it's slightly longer than OEM. When I first installed it, it had a kink in it. I was able to squeeze it out and it maintained its form, but it did give me some pause.
Daniel
2025-02-27 18:46:13
Excellent product. It feels really well made. Zero leaks so far on my E90 with the N52 engine. Just be careful to not push to hard your radiator when installing, you can break it, it is more likely if you have the original radiator
Juan
2025-02-18 14:47:03
Good product but it is too long for the n52, I was able to trim 2-3 inches off the hose part and re-clamp it onto the plastic connector.Had to use a dremel to cut the metal ring that holds the hose onto the plastic part.
John Passmore
2025-01-07 13:26:27
Wrong angle. Hose is too short. Will have to use the old hose and cut the clamps off. If you’re wanting to go the cheap route then you will have to diy this to make yours work. I’d suggest save your time and buy the right one for a bit more.
Recommended Products
