Your cart is empty.
Your cart is empty.Product Description
Low Hopper Model
Perfect for grinding small to medium batches of grain/corn.
High-quality Mill
This high-quality cast iron grinder is hard enough to ensure a long-lasting performance.
Easy Assembly
No tools required, just position the mill on a countertop and start placing every piece as shown in the manual.
Glen
2025-08-11 13:12:43
I am happily impressed. Made in Colombia, not China. The plates align well. Large pad for clamping underneath table. Beautiful enameled finish, nicely boxed. Have not had a chance to put it through all its paces over time, but it does grind well. The hopper is only 5", but it still holds a sizeable amount, and unlike other brands, there were no dents in the hopper: smooth and professional. Someone took some time here to do a nice job on the design details. All in all, a real bargain and an aesthetic pleasure at the price.A few suggestions:Add a rubber pad under the feet for clamping. Even while tightly clamped, it tends to slide on the table top, due to the smooth enamel finish.Add a splash guard over the top of the grinding plates so material doesn't splatter out the top.
ScottR
2025-07-26 15:26:49
Easy to assemble. Seems strong. Easy to grind corn into small chunks.
Vermont Gal
2025-07-12 18:58:52
I’m using this for grinding wild clay and for recycling leftover clay from making pottery. Works great for this purpose. Wear a mask to protect your lungs!
ddennis
2025-06-30 12:22:07
Excellent corn grinder and heavy duty construction. Does not use ball or needle bearings, is metal to metal shaft through case. I set it at a wide setting and turned deer corn into coarse cracked corn for my wild bird mix. Set it to the tightest (fine grind) setting and after three times through the grinder made cornmeal. This is not a flour grinder, so set your expectations accordingly. As mentioned in another review the metal base does not sit flat on the counter top. Can put shims under ears and is solid as a rock. Will probably take an angle grinder and flatten it out - not a deal breaker.
Steve
2025-06-15 14:20:27
Great for grinding hard stuff: nuts, egg shells, corn. A bit difficult to figure out how to adjust it.
Kindle Customer
2025-05-27 14:33:34
The media could not be loaded.
ATIS V ZIKMANIS
2025-02-27 10:05:47
I used this to grind whole corn for masa for tamales. It worked well. Also used it to grind corn for polenta. It’s good but just a little difficult to adjust. But if you pay attention, it works well.
Darrell
2025-02-19 11:49:56
I wasn’t sure how well this product would handle cracked corn but it exceeded my expectations. Very solidly built. The instructions for assembly were a little rough but not so bad you can’t figure it out. It turned wet cracked corn into a nice coarse meal with just one pass through. I wanted it coarse so I didn’t run it twice but I’d bet it would be a fine grain meal after two passes.
Recommended Products