Your cart is empty.
Your cart is empty.When it comes to spot & broadcast spraying, the Everflo 12V 7. 0 GPM on-demand 12V diaphragm pump is the king of the hill. With premium components & cutting-edge engineering, Everflo provides the flow You need. This pump is loaded with features such as a Honeywell Micro switch, corrosion resistant Viton valves & Santoprene diaphragm & fiberglass-reinforced polypropylene pump manifold with ½” NPT port. Other features include a silky smooth valve design for faster primes & a unique pressure switch that slowly cycles The pump to reduce wear on the motor & switch. Save battery power with the automatic power switch that turns off pump when no flow is needed. Approved for use with Round-Up & other agricultural brand herbicides & insecticides. Has standard mounting pattern to fit most sprayer tanks. Replacement 12V diaphragm pump for variety of makes & models. Can be used for other fluid transfer applications such as disinfectants and sanitizing (pump will need to be flushed and clean after-use). Handles up to a max of 60 PSI & self-primes up to 12'. Max Fluid Temp:140° F
W Ford
2025-08-30 16:42:59
Replaced an older pump that was still working on an Irontron 8 gallon ATV sprayer. The older pump had lost some pressure and this one works great. Total replacement time might be 10 minutes. Unit is very quiet. When I use this unit I usually spray fire ant killer, 2-4-d, or Roundup. Clean the unit after each use!!!!I get amused by people who rate a pump as not lasting very long but works good when it did. I have to believe that many users do not clean the tank/pump after each application. I learned the hard way, but now I do not have any issues with pumps. There is not a pump sold that will withstand harsh herbicide/pesticide chemical on the interior seals. If you clean the tank/pump after each use it will last a long time. Here is what I do:1. Drain the tank of any remaining fluid2. Add water to the tank and then drain it again3. Add about 2 inches of water to the tank, power up the pump, and spray the water out4. When the water hitting the ground loses the suds or soapy appearance the unit is now spraying mostly water.5. Unpower the pump and squeeze the lever on the wand to remove the pressure inside the pump.6. Store the unit for the next use. I always leave some water in the tank, but not in the pump.Good luck. It only takes less than 5 minutes to clean.
JMB
2025-08-14 13:25:17
Bought a sprayer from Northern Tool to replace same one that I had used for many years. Didn’t think to check warranty on newer one before buying. It lasted 3 1/2 months and I found out it was only guaranteed for 3 months. Ordered this one and it works great. Much cheaper than a replacement from NT, and much better pump!
dan
2025-08-03 11:01:23
The OEM motor rusted up -- it seems that this piece of outdoor equipment is not even water resistant!Anyway, I needed to replace the motor and this one works perfectly. It was easy to install, as it used the same mounting bolt pattern as the original.So far, works great, but I am keeping a tarp over the sprayer, now.
Johan Weijgers
2025-07-22 17:09:39
I bought this pump for building my own Softwash system.It works perfectly, only we have to try it out in practice to see how it preforms.We living in the Netherlands the only issue we have to find the right connectors to connect this pump to garden hose.
Nilton Junios Antes
2025-07-19 18:08:51
The media could not be loaded.
Jewellweed
2025-07-15 12:35:49
Kinda unorthodox packaging but I’m not planning on babying the pump. Was a bit damp on arrival.Pump didn’t work at first but it turns out a fuse blew in my wire harnesses,(not the pump fuse) was only a 7.5amp fuse. Threw in the correct size and it’s been running well.Iv had 4-5 of these and they normally last me the better part of a year running caustic chemicals through it. I rinse with about 5 gal H2O after each use.
Cold
2025-05-28 12:33:06
Purchased many 7GPM Pumps from everflow through out the years and now they changed how their pumps are built. The new version only lasted me about 4 months.The older model lasted about a year maybe a year and a half.Writing this from a softwash job I’m at right now and the pump decided to kick the bucket midway through. These things aren’t cheap, so to be spending 260$+ every 4 months adds up
Dave
2025-05-01 21:03:50
Have used it probably a dozen times now over the last month and keeps working.. even if I was to get only one season out of it, it’s Worth it compared to the higher prices Of others, hope it keeps working for the next seasons to come
J
2025-04-16 16:09:26
Have one that's been in a work truck for 5 years, these things just keep kicking.I'm sure ours has on numerous occasions been run dry for numerous hours straight, been frozen solid and in turn heated more than it needed to be to thaw and it just keeps kicking.Has been feeding 100' of 5/8 garden hose every work day, moving on average 50 gallons/day for the last 5 years.
Richard Pellerin
2025-03-13 20:07:54
Super
Gerry D.
2025-02-19 12:42:03
Pump arrived before expected delivery date. Pump works as intended. ONly issue was the mounting bracketslightly different than original so longer screws required and did not have rubber mounts as old one did to reduce vibration.
JSC
2025-02-18 11:19:44
FUNCIONA MUY BIEN PARA ALIMENTAR DE AGUA DE GARRAFON A UNA CAFETERA SUPERAUTOMATICA
Customer
2025-01-11 21:25:53
It worked, but the flow was fairly weak - it then lost pressure a lot despite nothing being stuck in the chamber > it also has plastic barbs for connections which can be very weak to metal fastening clamps etc.
Recommended Products
