Your cart is empty.
Your cart is empty."This ZVS board uses high quality 1.6mm double layer fiberglass board, 30MM large inductance coil and stable 5-band resistors that ensures its stable performance. "
Scrimshaw
September 2, 2025
The media could not be loaded.
John
August 31, 2025
Well get a 3 post zvs. This one is a dud.. 24 volts in and zero out.
Kirt
August 18, 2025
This board is supposed to be a ZVS zero voltage switch for a Tesla coil; however, it seems that instead, it’s more suited for an induction heater. I suppose you could use it for a Tesla coil to make a Jacob’s ladder, but those boards typically have three outputs – two positive leads and one negative lead. The induction heaters have two outputs like this board.It does seem to work, but you need a fan blowing air over the unit to keep it cool. It doesn’t take long for it to heat up.Amazon Vine sent this product to me for an honest unbiased review. Would I recommend it? Yes, but only if you’re going to use it for an induction heater, otherwise, get a board with three outputs. Also, don’t forget a small cooling fan.
Jennifer
June 30, 2025
This board takes 12-30vdc and turns it into high frequency AC.I supplied it with 12 volts DC and it put out about 14v AC at 10 kHz (see photos).The output was quite consistent. I was able to tune it for exactly 10 kHz by varying the input voltage. The output voltage is dependent on the input voltage and the frequency of the output goes down slightly as the input voltage is raised.This looks to be a good board for driving a fly-back transformer to produce a really high voltage output.
Daniella.S
January 26, 2025
This is a nice ZVS driver. It's well constructed and had an intelligent design. It can be used for more then a few high voltage duties. I'll be using this to drive a fly back transformer for ultra violet uses. I'm happy with this product.
Recommended Products
