Your cart is empty.
Your cart is empty.Refret or repair your instrument with the same fretwire that is used by Fender. Made of 18% nickel-silver alloy that delivers a clear tone, Fender fretwire is pre-cut and pre-radiused to the same specs used to build instruments in our factories. Standard guitar fret wire pre-cut into 24 pieces and pre-radiused to 7" for guitar fingerboards with 9.5” radius.
Bodysnatcher
2025-09-06 13:23:13
If refretting a Fender guitar then these are great if you don’t want to mess with stainless steel frets. Came with a perfect radius and easy to sand and dress and polish up beautifully! Will buy again for another cheaper squier I have soon!
zeljko cvijanovic
2025-09-02 15:09:47
I recently acquired 2001 Mexican Fender Stratocaster. The guitar was great but frets were (ob)used to the point that the crowning wasn’t an option. These frets fit the job, especially since they were bent almost to the correct radius.Please note that some specialty tools were used to cut, mount and finish frets. Also, you need knowledge and experience to do the refretting - it was not easy, it took some time and patience, but it came out nice.See before and after photo
susan cusce
2025-08-25 16:22:54
Since they are going to be taller than your old frets you will need to put in a new nut at the same time. I pre-cut the new frets to length with a Dremel tool. Saved a lot of filing time. I still had to hand file the edges and tangs. Worked perfectly. Like painting, prep is the most important step. Make sure the old slots are cleaned out and the finger board top is clean where the fret edges will rest flat. I used a brass hammer and super glue to install mine.
Mikey
2025-08-16 12:13:46
Does just what I needed
Stephanie Gwaltney
2025-08-04 18:15:32
good stuff
Yes worked great
2025-07-08 18:38:07
Awesome
Pavle
2025-06-01 10:35:10
5++
Norma Gomez
2025-04-19 13:22:44
Easy to install. Nice that they are pre cut and pre radius. Will buy again
Charles Buchanan
2025-04-05 15:39:59
I acquired a damaged acoustic needing a new fretboard and truss rod. The old frets were badly pitted and couldn't be reused. So, I looked at possibles and ordered these. They come precut and after installation have to be trimmed down, levelled and polished. They look great and function well.
Adam
2025-03-24 18:15:38
Did a refret on a squire telecaster. These did the job !
Simon Woodberry
2025-03-02 15:41:37
Toute a bien été
Nolan Makow
2025-02-18 10:53:54
Got here fast good quality
Paul S
2025-02-09 15:48:40
Worked perfect for a vintage Epiphone acoustic guitar.
Recommended Products
$26.82
$ 13 .99 $13.99
$18.49
$ 7 .99 $7.99
$23.43
$ 9 .99 $9.99