Shopping Cart

Your cart is empty.

Your cart is empty.

Fender Pure Vintage Amplifier Handle - Black, 1-Screw,

Free shipping on orders over $29.99

$9.87

$ 4 .99 $4.99

In Stock

About this item

  • Genuine Fender Replacement Part
  • High Quality
  • Durable


Amplifier Handle (Black, 1-Screw, Vintage)


Mark M.
2025-08-29 16:20:06
Replacing the handle on my '76 Fender Twin was a breeze with this authentic USA-made part.If you're not sure if this is the right replacement part for your amp model, the critical dimension to check is the distance between the mounting holes, which is about 7-3/4". Anything greater will make it difficult to get your hand under the strap to pull it up, and anything less will cause the strap to bulge rather than lay flat when not in use. The strap has a slotted hole at each end that provides about an inch of slack for lifting when installed correctly.Also, if you're careful not to use excessive downward force when removing the old handle's bolts, the existing spiked nuts in the top of the cabinet will likely remain in place and can be reused. In my case, the new bolts fit the existing nuts perfectly and that saved a lot of time. Otherwise, I would have had to remove the chassis straps and take out the heavy amplifier section to get into the cabinet to replace those nuts.
Brian Barrett
2025-07-30 12:33:46
Works as it should. Easy to install.
Mark N.
2025-07-22 16:13:54
Perfect replacement!!!Mark N.
Mike Zarowitz
2025-06-12 14:13:49
Fits. Piece of cake to install. Way over-built for the Fender Rumble-40 bass mp (18 lbs) I bought it for. Easy to use. Out of superlatives...
TJH
2025-06-07 15:56:24
Looks and acts like the real thing. I used it on a non-Fender amp and now it sounds better.Plus, it comes with all the hardware.
Glenn Goy
2025-06-01 13:41:50
Exact match to original.
Big Ukie
2025-05-22 13:46:07
Fits great on my 1990's vintage Fender Electronic 30 acoustic guitar amp.
Chris
2025-04-13 12:57:35
These are familiar, and a direct replacement.Except the screws are too short!The first thing I noticed, was the poor plating.It may be QC, I hope so.the rubber looks and feels good.The metal insert is rusty, and thinner than I remember.Works as intended.
Richard
2025-02-25 11:53:33
c est parfait remplace ma poigne appli custom sienna 35
グレコ279
2025-02-07 12:08:20
純正ではありませんが、Fenderのアンプなどに使用しております。仕上げも綺麗で、とても気に入っております。出来れば価格がもう少し安いとサイコーなのですが。
極幸
2025-02-01 11:55:47
純正品なので問題無く交換出来ました。
Paul Lacourse
2024-12-17 12:56:34
Solide, dimension standard. Remplace, effectivement, n'importe quel poignée de 10".
里山ビギナー
2024-12-04 11:15:23
現物を見て、低価格のアンプについている取っ手とよく似ています。ネジ二本で固定されるので、重いものの使用はできないと思いますが、交換用には非常に便利です。よって、評価は普通の★三つです。(なんかフェンダージャパンブランドになったら、価格アップした様な感じ・・かな)