Your cart is empty.
Your cart is empty.Product Description
Victor Garcia
2025-08-21 19:46:09
I recently paired the Fireblack® Hi Temp BBQ smoker Gasket Self Stick with my Louisiana Grill vertical smoker, and the results were nothing short of spectacular.1. Seal Integrity: This gasket offers an impeccable seal, locking in all the flavorful smoke where it belongs: inside the smoker. Say goodbye to leaks and hello to more robust, smoke-infused flavor in every bite.2. Easy Installation: The self-stick design made installation a breeze. No fuss, no mess - just peel, stick, and you're ready to smoke.3. Heat Resilience: Capable of withstanding the high temperatures of serious BBQing, this gasket is built to last. I've used it repeatedly with no signs of wear or degradation.4. Economical Efficiency: By preventing smoke escape, it conserves both fuel and wood chips, making every smoking session more efficient and economical.5. Enhanced Performance: Since fitting this gasket, I've noticed a definite improvement in the consistency of my smoking sessions. The flavors are deeper, richer, and more uniformly distributed.The Fireblack® Hi Temp BBQ smoker Gasket isn't just an accessory; it's an essential component for anyone serious about their BBQ. The improvement in flavor and efficiency makes it a no-brainer for Louisiana Grill vertical smoker owners. Happy smoking!
J Kohutich
2025-08-11 18:11:04
Very easy install, looks great and seals perfectly- not sure of the durability yet, but enough came to do my PRO 575 twice. Cheap and easy enough to do once a year.
Brysen Lamb
2025-08-09 11:32:10
Was able to use this roll to do two smokers. Both smaller units but worked out perfect for me.Make sure your surfaces are very clean and free of any risidual smoke. Alcohol made quick work of everything.Installation was a breeze. The easiest way to trim was with a sharp pair of scissors.Not a fault of the gasket but you aren’t able to put it along the top and by the hinges. It keep your door open because of the thickness of the gasket. Works well everywhere else around the lid but wasn’t able to make it seal the top.
Robert M Chadwick
2025-07-18 18:22:45
I got this gasket to put around the firebox door for my Dynaglo smoker. It went on smoothly. The self-stick backing was a little tricky to peel in a couple of spots, but otherwise it gave me no issues. Stuck perfectly and has held up through a couple of smoke sessions and some inclement weather with no problem.I thought it would be a little bit thicker but the size is clearly disclosed so that's on me - just remember that 1/8" isn't as thick as you might think. It is doing its job by making a tighter door seal and preventing excess smoke escape. It's made of a coarse felt-like material, not a solid foam or silicone, so expect that.I have no complaints.
Jim
2025-07-17 14:50:06
Used on Oklahoma Joe Canyon Combo to seal around smoke stack and door openings where air/smoke was escaping. Did the trick and plenty in roll to complete the job. Easy to put on and so far is staying put.
Little John Sierra Leone
2025-05-26 18:16:26
Applied this to my Recteq Deck Boss 590 and it works great! It really makes a tight seal with no smoke leakage from the lid. The only smoke that that leaves the smoker is through the intended vents on the back of the unit.Highly recommend adding the seal as soon as the grill is assembled & still clean. Take your time with the application because once it is on it may be difficult to adjust.
Wylie Wiggins
2025-05-16 11:48:04
During assembly I sealed my Oklahoma Joe's Rambler's smoke stack, vent, lid and ash tray successfully with this.Compared to pictures I've seen this worked very well as little to no smoke escapes other than through the smoke stack, as it should be IMHO.Durability has yet to be seen as the sliding vent may loosen the adhesive over time but so far so good.I did clean all adhesion surfaces with denatured alcohol prior to applying this sealing gasket material.
R. Silva
2025-05-15 10:00:53
I followed instructions and cleaned the application areas, but smoke is still escaping from the door edges. Disappointing.
Luggio
2025-05-03 14:09:23
Dopo che il mio povero weber master touch, dopo essermi caduto, ha subito un bel bozzo sul coperchio, non si chiudeva più bene. C'era molto trafilaggio di aria e non riuscivo a mantenere la temperatura, i carboni non si spegnevano e si consumavano tutti.Devo dire con soddisfazione che così ho risolto, anzi ora si chiude meglio di prima, è diventato praticamente ermetico.Secondo me si può usare anche su un dispositivo nuovo per aumentare la tenuta.Su quelli già precchio usati come il mio è bene pulire prima tutta la zona dove verrà applicato questo nastro.Con un rotolo si fanno 2 weber da 57, quindi ottimo anche per acquisti di gruppo
alejandro m.
2025-04-24 11:42:45
Excelente producto, tengo un weber de 22" y por desgracia se me golpeó la tapa y no hacÃa su función de ahumado, con este producto pide solucionar el problema , incluso me atrevo a decir que quedó mejor el sellado
LP
2025-02-25 13:45:26
Used on a large BGE - very easy to apply.
Antonio Scolari
2025-01-24 12:56:46
El empaque está muy bien, me sobró un poco y eso es excelente,
Dan Salazar
2025-01-10 11:52:17
Ahora ya no escapa el humo de mi asador.
Recommended Products