Your cart is empty.
Your cart is empty. Fitment:
for 2010-2018 Ford Explorer
NOTE:You should disassemble the A/C lines and look at them before you order to make sure they will fit.
Apache-=CW=-
2025-09-02 14:17:05
My wife’s 2013 Explorer was having the known issue with the rear a/c leaking. I tried a new set of seals and O rings which only lasted a few days. Rather than keep messing with it I decided to give these a try.The O rings it comes with are ok, what they give you is two larger and two smaller. I guess the idea is to skip using the factory plate with the rubber seal. What I found is that the smaller O rings are a bit too large, but also the larger O rings will not give you a good seal.What I ended up doing is using a new set of factory O rings and seals. The larger O ring fits well in the new block off plate so I left it in place and put the factory spacer/seal over it. I put the factory O ring on the cylindrical part and assembled.I vacuumed for about a half hour, and put back in approximately 1/2 of the recommended charge from the data plate on the radiator support. Nice and cold now.Hope this helps
Andrew
2025-08-05 09:50:33
The grooves that are machined out for the o-rings are cut way too deep, which makes the o-rings very sloppy and therefore would never seal. Completely wrong. Don't waste your money.
Bonifacio Doral Jr
2025-07-16 12:28:53
Ford quoted my about 4k to replace the hard AC lines on my 2013 explorer. Thank goodness I looked up a solution and this saved me tons! The front AC is still enough to cool my truck!
HeritageServiceCentre
2025-07-03 16:51:45
The cuts for the O-Rings are too deep for the included o-rings. We attempted to use thicker a/c o-rings and these still leaked. These could be a very good product if that issue was resolved.
Anthony Brosky
2025-06-03 15:47:52
Great product quick shipping
Customer
2025-05-08 21:47:58
This product was advertised to fit my 2014 Ford Explorer. It appears to be the wrong style for this application. The original design uses a steel / rubber gasket and an O-ring this design is two O-rings, does not seal properly.
BRIAN
2025-01-07 10:52:10
All o ring grooves too big. Won't even hold avacuum much less pressure. Right idea just piss poor quality
jose m vidal
2025-01-02 16:39:41
i have to use different size orings to make it seal.
axel
2024-12-13 18:25:57
This product fits my 2012 Ford Explorer. It passed the leak test and front AC works perfect.
Recommended Products
