Your cart is empty.
Your cart is empty.FloTool, by Hopkins Manufacturing, offers the most comprehensive and highest quality offering of fluid handling products. Driven by innovative, no-mess product solutions, whether you’re changing your oil, topping off the antifreeze or checking all your automotive fluid levels, FloTool has the right application. FloTool's Trans Fluid and Gear Oil On-Off Filler Spout has a reduced tip for transmission filler tubes.
wayne
2025-08-17 18:51:31
I have been using this to refill the DEF on a late model GMC truck for about two years now. Since General Motors decided to put the refill port in the most inconvenient and difficult place to service the DEF and after spilling this corrosive liquid every time I tried to refill, I finally found the almost perfect solution by using this refill tube. The 2.5 gallon DEF that you can purchase at many locations has a very flimsy spout and was very difficult to get started and pour into the refill port. This refill spout is sturdy and has a good solid shut-off feature. I securely hand tighten the spout on DEF container and lay it on it's side while inserting the tube in the refill port. Then just twist the shut off to start the flow. I also take my pocket knife and stab a hole in the top of the DEF container so it will vent and pour smoothly. After it's empty, I shut off the valve and remove the whole thing. It works great. I then rinse out the refill spout and put in a clean zip lock bag and stow under my rear seat, ready for use when needed. GM finally got smart and relocated the fill port to a more sane and sensible spot.
Customer
2025-07-29 10:27:34
Well made, note there is a adapter piece you will need to remove (white collar) for it to fit quart bottles. Adjustable flow is a must for fluid change on my ATV differential that only take 9 oz. No leaks. One thing I would improve would be to add a stiff tubing as it's a little soft but usable, also make it about a foot lomger.Will be ordering several more to keep fluid cross contamination!
Knock
2025-07-15 09:39:02
I had to return this because I bought it hoping it would fit on a milk jug (it doesn't), but I'm leaving a review because it's a super little product! It feels like high quality material; the tube actually flexes without crimping; and the having two sizes of attachment is really nice. Don't hesitate to buy this for what it is intended for!
mark
2025-07-06 11:22:18
Got a couple of these to work on stored motorcycles, but in the mean time I needed to replace a toilet. Works great to drain almost all of the water out of the tank and the bowl with one caveat. When you stop the pump about a half cup of fluid drains back out of the inlet piece. The first time, I didn't expect it and fluid ran all over my shoes. If this would have been gas or another volatile fluid, it would have been a big mess.One minor complaint is that the inlet pipe is a solid - unbendable - piece of plastic unlike the nice flexible outlet pipe. This limits where you can use it. For example, the toilet tank has a flat bottom with open access - works perfect. The toilet bowl curves on the bottom and is lower in the back making it impossible to angle the pipe for maximum fluid removal. Maybe minor, but car and cycle gas tanks are never just a large open tank with a flat bottom. I will experiment with adding a flex piece on the end of the inlet pipe and see what happens.Lastly, I'm never sure of the quality of the seals in this type of product, but I will try it with fuel and see what happens after time. Still a good piece to have in your tool kit.
Customer
2025-06-17 09:27:07
2000 Honda CRV. Since the transmission fill hole is pretty low in the engine compartment and hoses in the way, would've been much easier if the tube was 2" longer. It was still manageable to get the tube into the fill hole. Other than that, works pretty well.
Barry Shane Bissessar
2025-06-01 12:18:40
I purchased this Funnel primarily to pour an additive into my 2006 Volvo S60 T5 Transmission. For those of you who have a car like mines, would unhappily agree that the placement of the Dipstick, is in a loathsome area on the Transmission. I mean, what were the Engineers at Volvo thinking!!Nonetheless, with this flexible Flo Tool Filler Refill (or funnel), I was able to safely pour the additive into my S60 Transmission without any spills. I am very pleased with my purchase!Barry S. BissessarTrinidad. W.I.
Ron K
2025-04-16 14:54:57
Works as advertised. No better way to add fluid to a differential to a side by side.
Customer
2025-03-10 15:27:06
The end needs more fittings like an elbow. I used it for transmission fluid and if it had an elbow at the end the hose wouldn't have bent and made it more difficult to use.
Lee the tree man
2025-03-09 10:33:29
Works great to fill gear case on tractor and Ranger
Nik
2025-02-14 10:03:06
It fits 1 liter oil cans, but not 5 liters oil cans, and not 375 ml additives cans.So it can be occasionally used.It's too short to reach differential filler hole.
ML
2025-02-05 18:44:32
Works well
Tom
2024-12-15 12:47:56
Perfect For My Needs In The Garage Easy To Use
MurrayF
2024-12-12 12:48:29
Worked as per design
Recommended Products
