Your cart is empty.
Your cart is empty.Customer
2025-08-31 15:44:12
They came on time and are sharp.
Cardoc
2025-08-17 17:08:29
Great value. They fit my Simplicity 5/14 with just a little grinding and new bolts. Simplicity is no longer made so what's left in stock is super expensive. Works great now.
john
2025-07-01 10:55:34
Wood chipping
Retro Piano Guy
2025-06-06 16:45:09
Direct replacement intended for the LCE01 chipper that I bought earlier this year. It made a huge difference! Before the replacement, I had to push most branches into the chute, and they would vibrate a lot and sometimes rattle a lot. Now the machine pulls the branch in, sometimes I don't need to push it at all. Also much less vibration and almost no rattling.Installation was 45 minutes. You have to remove a lot of 1/2 inch bolts to get access to both front and back of the blades. Once the hopper is off, the machine wants to tip over, so I put some stone blocks under it for balance. The blades are connected with an alan wrench on front and lock washer / bolt on back. No need to make it extremely tight. Just give it a good tug so the lock washer smashes a bit, and that should do it.
Ken
2025-03-31 19:37:50
It fit my chipper/shredder
Customer
2025-03-27 18:56:33
I pulled up the Great Circle Wood Chipper order receipt I bought two years ago. The recommended blades had two screw holes. However, when I went to install the blades, I noticed that my original GC Wood Chipper's blades had three screw holes and not two. Be careful not to follow the recommended blade parts and check your machine first to ensure the correct blade parts.
Kindle Customer
2025-03-19 17:45:52
While this result came back off a query for Yard Machines chipper blades, they do not fit the 10 hp unit. The bolt spacing is too narrow by a 1/4".
Stuart
2024-12-26 16:16:02
I installed the 2 blades and it was simple and quick. Worked great. I then sharpened the old blades and will keep them as backups
Recommended Products
