Your cart is empty.
Your cart is empty.Product Description
Gardner bender Low-Volt Staple Gun. Safety handle for compact storage. Superior quality at an affordable price.
From the Manufacturer
Gardner bender Low-Volt Staple Gun. Safety handle for compact storage. Superior quality at an affordable price.
Customer
2025-08-20 21:42:17
Works great for stapling up lights. Well enough made. Easy to use. Cheaper than so many xmas tree light specialty tools that are marketed. This does the job, costs pennies to use and is not fussy.
MKES
2025-08-02 10:21:12
I have used both the Arrow T25 and this Gardner Bender MSG-301. Both work fine. The MSG-301 is less prone to crush down hard on Ethernet wires. It pins them well but leaves a little breathing room compared to the Arrow. This can come in handy – allowing the wire to slide in order to add or remove slack after it’s been stapled. If you prefer a super tight hold, where the staple crushes into the wire a fair amount, then the Arrow is for you.
Purchaser’s opinion
2025-06-14 10:24:23
Best for cable staples on drywall. Not much of kick to shot a staple
wizdomseeker
2025-05-12 15:27:54
Bought this with the staples. I found that it worked great! I was able to secure cables to trim or anything with not problem VERY quickly over a hammer and cable holder clips and it looked nice and neat. Time is money and this cuts time in less than half.
RACHAEL SLIVKA
2025-05-11 15:33:44
Item arrived quickly, but was packaged in a padded envelope. Due to the weight of the item, it should have been packaged in a box. The clamshell packaging had split at one end, but thankfully the stapler was not damaged.Be aware that the stapler does not come with any staples. I had already purchased the staples I wanted to use from a local Home Depot. I did not read the instructions and loaded the staples from the rear of the staple guide. This was wrong and the stapler did not work. Doh! After reading the instructions, I realized that you need to load the staples in front of the staple guide. In simple terms...- turn the stapler upside down- slide out the staple guide/holder- drop in the staples- slide in the staple guide/holder.After loading the basic Metal round cables staples, i did some testing on cat5/cat 6 cables.On cat5e the staple went in well into hard wood and drywall. The staple did not pinch the cable and there was enough of a gap that you could slide the cable under the stapleOn cat6 the staple was tight on the cable but it was not pinching the cable. You would not be able to slide the cable so make sure to not leave any slack.I did not test coax.The stapler itself was easy to use either vertically or horizontally. I work installing low voltage cabling and it should be exactly what I need for a specific project. I can also see myself using it to quickly secure a single cable in a phone room/IDF into plywood or drywall.
Ted E.
2025-05-02 13:37:30
great for low voltage wires. I hve used for cat5 cable, sprinklerr wire, doorbell wire etc. works well and no chance of accidentally stapling the wire.. which I have done on the other staple guns and fried out a sprinkler timer (with the other kind of stapler)
Jim Fraley
2025-03-13 13:39:29
I like to do a quality job of wiring when I run network cabling and this stapler has allowed me to easily get the job done without stapling though cables or just letting cables dangle.
Super Toaster
2024-11-29 16:07:47
The design of these staples makes it impossible to accidentally pierce a wire while stapling. My T25 stapler worked reliably but would regularly shoot staples through cables that were close to 1/4" in diameter, ruining the entire wire run and costing me hours of labor. These staples are relatively discrete while still doing a good job tacking the cables in place. Especially useful for exposed cabling along trim, on telephone poles, etc. I just wish they made stainless steel staples.Update: These staples have a flaw. If you don't firmly hold the stapler level to the surface, or you hit a knot, there is a 20% chance the staple will buckle inwards, and crush or slice the cable jacket, potentially shorting the wires within. I had to re-run a 300ft cable in a new construction attic space because I didn't test it before they closed up the ceiling and insulated. It was a miserable experience the second time around. Use with caution, and test your wires if you think one got nicked so you don't end up with regrets. I like the look and fit of these staples and will still used them with caution for exposed wire, but in concealed spaces I am going to go back to insulated T59 staples.
Ruben M. Roldan Chavez
2024-11-23 14:56:30
SerÃa muy recomendable que trajera grapas.
Recommended Products
