Your cart is empty.
Your cart is empty.ORIGPARTS Gas Grill Replacement Parts Manifold Main Burner Control Valve for Weber Spirit(2013-Current) & Spirit II E-210, E-310, E-315, E-320 Propane(LP)
adetor
2025-09-06 09:56:08
It Fits and works perfectly
J.J. Daniels
2025-08-13 13:13:48
Ordered two and had them both installed in under 20 minutes. Perfect fit for my grill
James R.
2025-08-06 11:35:41
I installed it myself works perfectly
Samuel
2025-07-16 11:03:02
Part was received quickly and was well built but was not quite a perfect fit. Nevertheless, I was able to work through the fit issues pretty quickly an was able to install it in around 20-30 minutes. It has been working perfectly and would certainly order again in the future!
Sean
2025-06-30 10:58:19
Works perfectly, fits weber spirit 300 series
T. Coll
2025-05-05 14:29:10
Works as intended. Fit well.
Kurt
2025-04-30 14:54:57
I have a Weber Spirit II 210 grill and the old valve was sticking and ended up deforming the plastic in the handle that went over the valve stem. This valve was not an exact replacement. Supposedly to turn the valve off, you turned counterclockwise and when it comes to a stop, it was 90 degrees to the right of the old valve position. No big deal, as I could live with the handle pointer not facing the same as the other valve on the grill. But it didn't allow gas to pass in any position. I tested the old valve by blowing into the inlet and it allowed air to pass when opened. I tried the same with this valve and nothing would pass in any position -- even after I took out the orifice. Just didn't work
I'm a real customer
2025-04-27 15:55:22
After several years of keeping the grill outdoors these dials become brittle and no longer turn.Luckily you do not have to dispose of the grill but can replace these as they wear out. 2 out of 3 so far after 10 years outdoors without a cover. That's pretty good!NOTE: there's only 1 screw because you only need one.Don't freak out if it doesn't have 2 like the one you're replacing.The bracket is slightly different and only needs 1 screw to secure to grill.Works perfectly and better than throwing away the entire grill for a $600 new grill.Good luck
Andrea Lai
2025-04-19 13:19:58
As many already stated the nozzles is too big for my WEBER SPIRIT E-210. The flame were much too big. I had to swap the old nozzle in. The installation is easy and worked.
Werner T.
2025-04-17 20:03:02
Dieses Steuerventil wird als original Ersatzteil für den Weber Spirit beworben. Der Einbau ist einfach, jedoch kommt noch dem Zünden die böse Überraschung. Flammen schlagen über die Flavorizer Bars. Die Grillflamme lässt sich gar nicht so klein regeln. Das Grillgut würde total verkohlen. Ursache sind die eingebauten zu grossen Düsen. Ich habe mir geholfen die Düsen von den alten Steuerventilen auszubauen und in die neuen Steuerventile einzubauen. So etwas darf nicht passieren !!Ausserdem steht auf den neuen Ventilen made in China drauf, was bei den Alten nicht der Fall war. Dies kann kein Original Ersatzteil sein
Volker Gruenewald
2025-04-15 13:02:43
Der Regler ließ sich problemlos einbauen! Sehr passgenau und tut das was er soll! Bin sehr zufrieden!
Roland9 Johansson
2025-04-02 18:40:14
X
Jose A
2025-01-27 20:33:53
More or less fits but is larger than the original and doesn't fit exactly in the proper place: a bit above the original hole (but still fits); and the holding screw hole is not aligned.
Recommended Products
$23.80
$ 10 .99 $10.99