Your cart is empty.
Your cart is empty.All Gates radiator pressure caps are constructed of heavy-gauge metal
Michelle
August 22, 2025
I have a 1979 ford 455 skip loader fit the radiator great gates is a good quality brand I recommend
James G. Collura
August 9, 2025
This is ok, just not like the picture shown. I bought it based on the picture for a street Rod that has an aluminum cap over it. I made it work, but I bought it based on the advertised photo.
Kimberly Cogo
August 3, 2025
Good value.
ventingisok
July 26, 2025
Quality is good and parts work as they should. The spring also has more resistance to the push than the autozone cap I was using.add: I also used to have a little leak at the gasket. After this cap was put on, the leak stopped. I guess what happened was autozone cap was not handling the radiator pressure which escaped through the gasket.
Mike
July 21, 2025
direct replacement for what I needed
Steve
July 15, 2025
I installed it as part of a coolant flush on my '91 Jeep Cherokee since my old one was starting to get cracks in the gasket. It fit fine and looked identical to the one it replaced. But then all my coolant sprayed out and my engine overheated. I refilled the cooling system with water and let it warm up and it was just spraying out fast from under the cap, not going to the overflow tank. I couldn't see anything wrong with it but it just wouldn't seal around the radiator neck.I went to Napa and picked up another new cap and another couple gallons of coolant, and pretty much did the whole job again. I ended up getting a refund from Amazon on this item, but still spent close to an extra $40 for the Napa cap and antifreeze to get my Jeep running again.
Leo Guzman
July 6, 2025
Feels like a cheap cap replacement, the hold down grips are shorter than original cap which it does not provide the confidence to support the pressure, it does fit ok, I will keep looking for a better replacement, I use to trust Gates with their product however this time I'm disappointed the box says Gates but inside the cap is Motorad
fmwardalot
July 2, 2025
I bought this to replace a lever cap. The lever cap seal allowed air into the radiator. Coolant from the overflow tank would not get sucked back into the radiator under vacuum with the lever cap. Put this on, and coolant now flow back into radiator to keep the system full. No lever, so you can't release pressure when hot, but really, how often does one need to do this?
juan
July 1, 2025
Muy buena calidad
Christopher Brown
May 3, 2025
Perfect fit for my 1987 Ford Bronco Full Size. Quality seems good, holds pressure, no leaks
RobtCM
March 21, 2025
Great fit, great quality. Used for a 1980 Fiat Spider 2000
Scott
January 31, 2025
Fit perfectly to replace my original old cap on my 1992 ford f250 diesel radiator.
Recommended Products
