Your cart is empty.
Your cart is empty.DriveAlign Idler Pulleys provide OE-quality fit to passenger cars and light trucks, performing as a locked center tensioning pulley, an automatic belt tensioner pulley or an idler pulley.
Joshua Lewis
2025-08-28 14:40:13
Works on 08 charger rt
Bill
2025-08-19 13:22:59
Thought I'd be smooth and stop at changing the belt alone to rid the wife of squeal. Fast forward 2 months and squeal is back. Not anymore with this pulley.
Marcos
2025-08-12 14:44:37
Great
Z. M.
2025-07-11 13:38:12
Fits exact as they are what comes OEM. Quiet but I replaced them when I replaced the serpentine belt at 85K. The 2.7T uses two of these total. One on the idler and one on the tensioner.Hope they last a while!
Mai K.
2025-06-17 12:14:36
Great replacement for toyota 1.8 1ZZ-FE motor. So far so good. Make sure get the star socket to get bolt off.
Customer Review
2025-06-04 21:54:00
perfect replacement for tensioner on 2004 Corolla. Got rig of the squeak and much easier, less costly to replace than the entire tensioner unit. Yes, it is plastic but the plastic part will never wear out. What wears on these is the bearing and you can have a pretty high confidence level in the quality of Gates bearings.
LexusTech48
2025-05-26 17:49:33
Bought a 1999 Toyota Corolla with 220k on the clock. Ive no doubt she's got plenty more miles in her, but some things were in need of repair and the tensioner was one of them. Pulley was very unhappy, and the belt had seen better days.This Gates pulley was the perfect fit for the tensioner assembly that was on the car. Mine did require a torx socket to remove, but it can be done on the car. Remove belt, pop the cap off the old pulley, removed torx bolt, swap pulley, install torx bolt. Old cap wont fit this Gates unit, but no biggie.Installed the new pulley with a new Bando belt and she runs like a sewing machine. Highly recommend.
James
2025-05-23 11:57:25
Perfect replacement for Volkswagen mk4 1.8T/2.0 serpentine belt tensioners. A lot less expensive than replacing the whole assembly, and at a fraction of the cost.Installation is simple. Remove tensioner assembly from engine, apply PBlaster to back of pulley bolt and let soak. Then take a mapp has torch and briefly heat the mount around the bolt. Flip it over and remove the bolt now that the PBlaster and heat break it free. Then install the new pulley.
DAVID B.
2025-05-19 15:27:43
Se ajustó perfecto a SUBARU OUTBACK 2.5L 2011
Nuno Est
2025-05-18 18:11:15
Fits 4L Jeep TJ, good delivery well make part.
Leonardo Coyotl
2025-02-14 11:51:13
Muy buen producto en cuanto a calidad y precio
Bert
2025-01-11 14:40:10
My Ford explorer tensioner pulley was making a bad bearing noise. Since the pulley on the OEM tensioner is a Gates, I ran the part number stamped on it and and found I could just replace it at a much lower cost rather than replacing the whole tensioner from Ford since the tensioner still had good spring tension to it. Better spending a few bucks versus spending a couple of hundred for the OEM tensioner.
Customer
2025-01-05 11:20:53
Exactly as ordered
Recommended Products
