Your cart is empty.
Your cart is empty.These Fender Covers provide your car with protection from scrapes, scratches and grease when working under the hood. They are made of non-slip material to prevent it from sliding off of slippery surfaces and also keep the tools from slipping off. They have a soft feel and is cushioned for protection. The strong PVC product is reinforced with nylon mesh and is completely washable. It is unreceptive to motor oil, coolant, lacquer thinner, brake fluid, etc. and will not damage your car paint.
S Mart
2025-09-06 15:28:51
Very happy with it fits and works great for my needs with my hobby car I’ve had 41 years now. Product is sturdy with strong enough magnets that hold just fine for me. No complaints at this point.
Clan Kingsbury
2025-09-01 12:16:06
Works well! Obviously the magnet won’t work if your vehicle is aluminum or plastic.
Alric808
2025-06-12 16:27:55
I bought this for brake fluid change to protect fenders from paint damage. Cheap insurance. Also helps if you drop a tool on the fender. Doesn’t slide off due to magnets sewn in.
Sue S
2025-06-07 15:10:36
Magnetic and works well, does not slip off.
Excellent fender covers
2025-05-27 11:39:31
These fender covers are exactly as advertised. Provide great protection and cover my fenders perfectly.
Atteboy
2025-04-18 11:32:41
The magnets are nice for holding it on the fender if you have steel fenders. It doesn't work on my corvette very well but that's OK. The quality is good regardless.
G. E. Glaum
2025-04-15 10:31:33
Because I'm a HUGE FAN if Gear Wrench tools (When my tools were stolen I replaced almost all of my old tools--which were all Snap On, Mac, and Craftsman--with Gear Wrench and I love them more than my old tools!), so I took a liking to these cover at first, and since my old ones were headed for the trash I figured I'd get a set of these. Well, in appearance these fender covers are nice, and I love the Gear Wrench Logo, but in function they are terribly insufficient. The flap that covers the tops side of the fender, which SHOULD be large enough to fit over the fender and into the engine compartment to provide full coverage, is a teeny-tiny little 2'' flap, with magnets sewn inside. WEAK magnets. This little flap is supposed to sit on the inside the fender's lip and be secured with these weak refidgerator magnets. I don't know about you, but most fender covers I've used have a large flap with two seams which drapes the cover over the top of the fender, then the flap sits inside the hood, acting as a counterweight, and then the rest hangs over the fender. Not these. Just a tiny little 2" flap. I found I had to secure the fender covers to the vehicle with a plastic clip, just to keep them from spontaneously slipping off the fenders. If you brush against them while working with them on the vehicle they'll end-up on the floor of your shop without some kind of fastener or holding device. Guaranteed. The quality of the material is fairly nice, but that doesn't do you any good if they are laying on the floor, instead of protecting the fenders of the vehicle you are servicing. I must admit that I expected these fender covers to be as "skookum" as their tools, but was severely disppointed. I'll still use them, though, once I get some naugahyde and sew a decent flap on the edge that goes into the engine bay. Then they'll probably be better than my ole Mac set that they will replace. I think I'll sew a little tool holding device on the flap, too. I still LOVE Gear Wrench, though. Just a little disappointed in this product is all.
L.D.
2025-04-05 13:53:08
From my perspective, I have purchased a lot of fender covers over the years and honestly, the ones from the factory parts counter are the best. Unfortunately, most don’t make them any more, so we have to use these aftermarket brand X types. This one is a high quality and I am thinking durable too. It’s made well, stitched nicely and plush. My only concern, and others have mentioned it too, is the size. It would be great if it were longer, both width and height. But overall, it nice. I have already purchased two and thinking about a third.
wayne o'connell
2025-04-04 10:03:00
This is the fender cover that you want when you’re working on your car. Tough looks great and magnets work very well. No slippage when you are leaning over the car fender. Very well made. Worth the money !!
DandyBurns
2025-03-25 17:34:07
Needed a cover for work. Really good quality and quite thick. I have spilt oil, coolant and sweat. Nothing has managed to penetrate the cover. Fluids wipe off well.I have used this since the start of Novemebr 2024 with no issues.
Frank Thomas
2025-02-20 17:03:23
great tool
Allan
2025-02-06 09:31:39
Very well made!! Great product as a Pro Mechanic this is a must!!! Very good quality
Les O'Brien
2025-02-04 17:32:56
Like this cover a lot. As other reviewers state, it is a bit on the small side. If using for a truck, best to go with something else. A small car - perfect. High quality and love the magnets
Recommended Products
$26.99
$ 12 .99 $12.99