Your cart is empty.
Your cart is empty.ACDelco GM Original Equipment Clutch Pilot Bearings or bushings are located in the center of the flywheel in the crankshaft flange. They support the end of the transmission input shaft while the clutch is disengaged. These original equipment clutch pilot bearings have been manufactured to fit your GM vehicle, providing the same performance, durability, and service life you expect from General Motors.
Customer
2025-08-15 13:16:13
GM OEM 1984-2006 Manual Transmission Clutch Pilot bearing. Used this to fit a 350sbc to a Tremec TkX. Measurements of the bearing are: OD = 1.0925, ID = 0.5905, and L = 0.7185
K
2025-08-13 15:42:17
Original GM Pilot bearing, perfect install
Cameron
2025-07-20 12:15:49
Worked fine in my 95 gmc seirra with a 5 speed attached even though it says “not for your vehicle†this was the closest i could find and it works fine.
Joe Kool!
2025-06-25 21:11:26
I put this in my 1992 corvette I did put in a bronze solid I m put brg when I put a stage 2 clutch set up in. But honestly it let you hear all the noise in the transmission cause the vibration it caused.But I buying GM products you will not go wrong for dependable.
Courtney D Post
2025-06-02 15:56:39
Great part nicely packaged. Installed perfectly and the input shaft on the transmission fit with no issues. Truck was a 1998 c1500 5.7 v8 with a 5 speed manual.
Luke Swanson
2025-05-31 12:08:32
No issues quality gm part
impala572
2025-05-15 15:38:05
Anytime you pull a manual transmission you should replace the pilot bearing. Little part little price but big problem if it fails. That’s why I use ACdelco pilot bearing it’s a great bearing.
chev
2025-05-13 18:27:40
Good fit
Chris brackstone
2025-02-13 17:25:30
GM part fits snug in the crankshaft, fits the tkx transmission well. Would buy again.
Recommended Products
$20.97
$ 10 .99 $10.99
$25.01
$ 11 .99 $11.99