Your cart is empty.
Your cart is empty.The ACDelco GM Original Equipment Parking/Neutral Position and Backup Lamp Switch is a GM-recommended replacement for your vehicle’s original component. It is mounted on the transmission and allows your vehicle to start only in the park or neutral position. It also serves as the switch for your vehicle’s backup lamps, turning them on when the car is placed into reverse. This original equipment parking/neutral position and backup lamp switch has been manufactured to fit your GM vehicle, providing the same performance, durability, and service life you expect from General Motors.
Toxie Odom
2025-08-04 16:46:28
Works great
Chris A
2025-07-25 13:30:19
Fit and worked fine. The service manual literally states as part of some diagnostics with the neutral safety switch to get a new one and try it. In my case, it did not fix a problem I was having with the Park indicator on the instrument cluster, but I left it installed since the one I removed was so old.
kelly hayden
2025-06-18 15:22:24
GM switch assembly. Same as the old one except 450,000 fewer miles.
Anna Henderson
2025-05-13 18:00:19
OEM replacement part for a 02-06 Escalade. Suited my needs very well and works as it should. If you have an issue with the PRNDL readout on your dash being incorrect, this is probably your issue.
Jim R
2025-05-05 16:25:41
DOA! Did not work. Mistake ordering open box. It had been used as it had grease on it!
Hesham Attar
2025-01-26 10:16:28
It really worked great. I was unable to start my vehicle without putting it in Neutral, I watched a youtube video and I was able to install it without any problem, Now I put the key in the ignition and it will start right away.the only thing it is missing a guide tap other models comes with it.
DB
2025-01-11 17:38:33
works well but be aware that the shaft that you go to it slide on has to be filed on the outer edge. The shaft often mushrooms out and will prevent THE switch from sliding on easily. If you force it on you WILL BREAK the NEW switch collar that goes around the shaft and if it is at all loose it will not work correctly This was not mentioned in the directions.
Lonnie Steinke
2024-12-26 11:03:06
Fixed the fact that neutral "gear" was not indicated correctly on my dash cluster. Can be a challenge to get new part to seat properly on the shaft, but I suspect it's that way with all brands. To get the electrical connector off the old part, pull the locking tab, then slide the "locking pin" to the right with a screwdriver.
Philippe
2024-11-17 13:01:10
Genuine GM partsCan’t go wrong with the original!!Fixed my starting problems
Yousef A.
2024-11-13 15:30:49
وصلت وبشكل جيد
Recommended Products
