Your cart is empty.
Your cart is empty.Glowshift's 1/8 NPT female to M10 P-1.5 male Adapter. This brass sensor adapter is ideal for oil pressure and fuel pressure sensors that will not thread into your stock port. If you are using this brass sensor adapter for a temperature sensor, a test port sender extender must be purchased since most temperature sensors will not fit through the borehole. It is recommended to use Teflon tape on each thread to prevent any leaks for a secure connection.
S. Gedney
2025-07-25 13:59:46
Replaced a fitting on a gas fire pit. This worked perfectly.
Customer for real
2025-07-01 20:17:10
works fine had to get creative to get to work on the max but threads into the bleed valve no problem. use the o-ring
Status
2025-03-15 12:47:40
Went to fit this to my block and the NPT side completely snapped off from the rest of the piece.And this was a CLEAN SNAP - meaning this piece was poor quality from the factory. Look at the images. And no, I did not over torque it.Now I have half of this crap stuck in my engine block that I have to drill out.
Recommended Products
