Your cart is empty.
Your cart is empty.Genuine Gretsch Electromatic Hollow Body G Chrome Tailpiece. 5" from the inside of the bend to the top on the string bar. Mounts to bottom of body by the strap lock/button and three mounting screws.
Brandon Campbell
September 6, 2025
The holes didn't line up and were a little too small for my Gretsch Rat Rod, but I made it work.
Willshire
August 29, 2025
You will have to get some screws from the hardware store. I took the piece in and matched them up. After spending about 70 cents I took the bugs you off and had it up and running in about 12 minutes. Use some masking tape to retain the bridge position if that kinda stuff makes you weary. I did this on two 5120s. 🔥🔥🔥
Customer
August 24, 2025
Item was fine
Doug M McNamee
August 4, 2025
This didn't work my new Gretsch Electromatic, must be for older guitars. The screw holes didn't line up, so I couldn't use it. However, this is a nice item and looks just like the one listed on Amazon.
Dvaltz
May 22, 2025
Great value and great look. Easy to install.
Timothy P
May 19, 2025
The product itself is a quality item, well made and up to snuff for Gretsch. This is advertised for the "Electromatic," but I am afraid it simply is not just a swap. The screw holes are in different places from the generic Bigsby tail that came with my 5420T Electromatic made in 2022. The screw holes in this piece are also too small to use the same screws. Removing the Bigsby also reveals another two drilled holes in the end of the guitar which hold strapping which reinforces (I presume) the trestle block in the guitar. All in all I wasn't confident about adding three more drill holes to the end of the guitar which would have made 7 holes in total including the ones for the reinforcement. As I said though, a well made piece but it just doesn't fit.
Brandon Campbell
March 18, 2025
The holes didn't line up and were a little too small for my Gretsch Rat Rod, but I made it work.
Willshire
March 12, 2025
You will have to get some screws from the hardware store. I took the piece in and matched them up. After spending about 70 cents I took the bugs you off and had it up and running in about 12 minutes. Use some masking tape to retain the bridge position if that kinda stuff makes you weary. I did this on two 5120s. 🔥🔥🔥
Customer
February 14, 2025
Item was fine
Doug M McNamee
February 12, 2025
This didn't work my new Gretsch Electromatic, must be for older guitars. The screw holes didn't line up, so I couldn't use it. However, this is a nice item and looks just like the one listed on Amazon.
Dvaltz
January 8, 2025
Great value and great look. Easy to install.
Timothy P
December 27, 2024
The product itself is a quality item, well made and up to snuff for Gretsch. This is advertised for the "Electromatic," but I am afraid it simply is not just a swap. The screw holes are in different places from the generic Bigsby tail that came with my 5420T Electromatic made in 2022. The screw holes in this piece are also too small to use the same screws. Removing the Bigsby also reveals another two drilled holes in the end of the guitar which hold strapping which reinforces (I presume) the trestle block in the guitar. All in all I wasn't confident about adding three more drill holes to the end of the guitar which would have made 7 holes in total including the ones for the reinforcement. As I said though, a well made piece but it just doesn't fit.
Recommended Products
