Your cart is empty.
Your cart is empty.This V-Block Pair is numbered and matched and are precision ground for accuracy.1 5/8" X 1 1/4" X 1 1/4"1" capacity.
Scott R.
2025-08-26 15:41:11
My application is a lot different than most people's. I'm using these in a laser lab to hold laser rods for testing. They'll do just fine for this. I noticed a lot of people have complained about the poor quality of the clamps that are included. I think they beefed them up in the interim, because the set I received appear to be quite heavy and stout. They're made from cast iron/steel with a 3/8(?) 8mm(?) SHCS for the bolt. Everything is heavily coated in cosmoline or similar material for rust prevention. I'm not too concerned about parallelism or flatness but they appear adequate. Considering a similar sized set from McMaster-Carr would run $300 and up, I'll take these!
don s
2025-08-09 12:13:02
These arrived in excellent condition and are the perfect size for my mini mill (7" x 27" table/ 4" vise). All surfaces are nicely ground and there are no rough or sharp edges. They are well matched as a pair.
Steve
2025-05-21 12:35:31
V-blocks are great for the money and for small hobby mills. The clamps are trash.
Robert A Miller
2025-05-11 11:22:26
Works well for the use, I've always had good luck with Grizzly products including larger metal working and wood working equipment.
Marc Lomax
2025-05-06 14:34:49
Very nice and sturdy little clamping blocks
Mark fields
2025-04-28 14:13:49
Did not have thumb screws like it shows. Has cheap Allen head screws. Clamps are near useless. Blocks are rusted.. Paint falling off clamps.
Mr Ed.
2025-04-22 17:45:11
Blocks are getting rust right out of the box.Have dings on it.
alan
2025-04-03 15:27:56
I was somewhat concerned when purchasing these as some of the other reviewers have complained that they are not match ground. For all intents and purposes mine are perfect. I inspected them on the surface plate and they are as precisely matched to each other as I can possibly measure. Haven't tested the clamps yet but they seem to be made better than some of the cast clamps you see in the v-blocks in this price range.
Henry-C
2025-03-27 16:55:11
It’s a drilling block use for drilling in the right place accurately
jorge beltran sanchez
2025-03-12 18:00:10
Más pequeños de lo que parece
Dennis Hirst
2025-02-09 14:29:48
great
Antony B.
2024-11-18 15:30:37
The clamp was poorly made. Both unit had the same issue .The V-block seem to be OK.
Recommended Products
$63.95
$ 27 .99 $27.99
$34.85
$ 15 .99 $15.99