Your cart is empty.
Your cart is empty.Product Description
White melamine edge banding
-
EASY APPLICATION
Melamine edge banding
-
First
You simply hold the edge banding in place, run over it with a household iron to heat the adhesive
-
Second
Wait for the edge banding cooling 10 minutes
-
Third
Use the back of a utility knife to scrape off the burrs on the edge banding.
-
Final
Finished
EASY APPLICATION
Melamine Edge banding is a thin material used to seal the sides.
Laminate
Cabinet
Door
Desk
Black edge banding
Compare
Melamine | Material | Melamine |
Black | Color | White |
250 ft | Length | 25 ft |
1/2 inch | Width | 1 1/2 inch |
| | Pre-glued | |
Melamine | Material | Birch Natural Wood |
Black | Color | Birch |
250 ft | Length | 100 ft |
1/2 inch | Width | 2 inch |
| | Pre-glued | |
Melamine | Material | Maple Natural Wood |
Black | Color | Maple |
250 ft | Length | 50 ft |
1/2 inch | Width | 7/8 inch |
| | Pre-glued | |
Melamine | Material | Oak Natural Wood |
Black | Color | Oak |
250 ft | Length | 10 ft |
1/2 inch | Width | 3/4 inch |
| | Pre-glued | |
- Melamine edge banding
- Birch edge banding
- Maple edge banding
- Oak edge banding
For carpentry
White Edge Banding
Melamine Edge Banding can make the work of carpentry easily.
Why Choose US?
TOP quality material
Simple Opertation
Robert Kaufman
2025-08-27 16:39:11
As a veneer, the material is plenty thick and substantial. It has somewhat limited ductility. It could probably be wrapped around a 1" dowel (your thumb), but much smaller than that and it will fracture. I think this would very rarely be an issue, but it means you cannot wrap it around a sharp edge of a cabinet. There is no guidance from the manufacturer about the acceptable temperature to set the iron. One reviewer was concerned that the banding could melt if the iron were set too high. However, Melamine is a thermoset, meaning it will not melt. It will decompose at about 650°F. It is also very resistant to ignition, and its ignition temperature is greater than 930°F. A typical electric iron will reach a temperature not greater than 450°F, so you do not need to worry about melting, or igniting the material. No need to put a layer of cloth between the banding and the iron. I don't know the melting point of the adhesive. Standard hot melt glue is dispensed at about 380°F. I also found the banding to be very forgiving, which I really appreciate. This means that if the banding is misplaced, you can simply reheat it, and move it, or remove it.I set the iron on cotton. The adhesive melted quickly, and set quickly enough that the band stayed in place. It was easy to trim with a razor blade. The stuff is really good, and easy to use.
Connoisseur Ceo
2025-08-26 10:10:22
The media could not be loaded.
Shanna U
2025-08-24 15:57:14
The media could not be loaded.
Mike Ryan
2025-08-12 17:49:06
The product came on time, matched my materials (White) and was easy to install. I used a double sided cutter and there were no tears or issues. I suggest that if your banding 3/4 material to order 7/8 banding. That’s what I did and it worked perfectly.
Laura M
2025-08-11 11:53:43
We just did some new melamine shelving in a closet but needed this edging to complete the edges of the boards. Applying the edging is very easy. You only need an iron on about 400 degrees(cotton setting). It adheres to the board quickly. I was skepitcal at first putting this on, figuring it would be harder to apply but was pleasantly surprised how easy it was. There may be a small learning curve but nothing too much. I tried to take pictures of the edges so you can see how nicely this banding works.
Alejandro
2025-08-02 16:42:41
I put these on a Murphy bed. It looks great, it is easy to put on. However, it is very brittle. You can easily snap it by accident. For example, I was handling the Murphy bed to install it in place and lots of places the banding broke off. However, I can see this being good for low traffic areas.
Lindsay L.
2025-07-15 16:51:26
Works great, easy to use on any chopping or pealed particle board/ laminate cabinets
Bones
2025-06-09 11:16:04
Exactly what I wanted. Great price, good quality. Plenty of elastic for me to make many skirts.Will purchase again when I run out.AnneMarie
Customer
2025-06-07 13:38:44
Parfait exactement ce que je voulait et le prix est abordable pour la quantité
Isabella
2025-03-22 11:41:14
It worked on my 40 year old cabinet, where the original strip had come undone. I don’t have an iron, so I used my steamer instead. 3/4 inch was the perfect size.Very happy with the results â£ï¸
THE1PRO
2025-02-14 11:40:20
250 feet for the same price as the big stores for 25 feet
Brian
2025-02-13 13:48:57
As long as I was careful with alignment, this tape fitted exactly my kitchen shelving thickness. I only had to sand a bevel to finish. Glue was good, I just used a cheap iron.Very happy with the result.
Cobra
2024-12-31 14:10:55
This product works great. Cut the strip, put it on and set your iron to wool and iron dry on top of the tape and it glues right on.
Recommended Products