Your cart is empty.
Your cart is empty.
1. Make sure you have factory stock bumper before purchase, the lip is not compatible with aftermarket bumper.
2. Professional paint job & installation is highly recommended, sand and primer is required before paint. Please test fit all items before painting and/or installation; products painted and/or damaged through installation will not be refundable.
For installation: Make sure your bumper is attached to your vehicle when install the lip. The lip will not fit if the bumper was removed from the vehicle.
(Note: The bumper needs to be installed on the vehicle in order for the front lip to fit. It was clearly mentioned in the general installation guide. When the bumper was not installed on the vehicle, it was not fully stretched, thats why the front lip will be few inches short because the front lip was molded on the original bumper that was installed on the vehicle.)
Vehicle Compatibility:
1996 Civic Factory Stock Bumper Only
1997 Civic Factory Stock Bumper Only
1998 Civic Factory Stock Bumper Only
John Ancheta
August 18, 2025
Fits close enough to the SiR lip. I didn’t want a lip that I needed to drill into my bumper, so chose this brand so I could use the Honda hardware. Mounting can be a little difficult, but just leave it out in the sun for a few hours before install and take it one bolt at a time. Looks great.
Dustin Warren
August 1, 2025
The lines and contours are just right. Even though the reviews were good, I was still skeptical because often times other peoples expectations are not as high as my own. When installing, do yourself a favor and remove the bumper. It makes for a much better installation. Also, make sure you have some quick clamps to lightly clamp the center section to the bumper so you can properly line up the outside edges. When you buy the lip, buy some inexpensive finishing washers and secure the outside edges with those and some bolts. NOT SELF TAPPING SCREWS. Gently tilt the lip up and away from the center section of the bumper (just enough to attach the double sided tape), then press it back down into place against the tape and use the quick clamps to hold it tight for a little while to get a secure bond. I also use the finishing washers in the center section because I think it looks good and gives added security that my lip isn't going to start flopping at high speed.
Kaelub
July 18, 2025
Came decently packaged but overall a perfect fit on my 98 civic lx
Erica
July 12, 2025
Good quality, but fitment isn’t the best. A bit to short on the ends. I have an OEM bumper.
Terrence Lewis
April 11, 2025
Love the look it gives my car. Fits good, the quality is good. For the installation process I remove the front bumper completely for a better and easier installation. Check photos to see end results
Noreen
March 5, 2025
The product does not need double sided tape. Installs perfectly without it. I only needed to add 3 extra screws.
Eriks.
January 11, 2025
Looks great unpainted, but once it does, looks even better
Justin King
November 23, 2024
It fits on my 2006 Honda CR-V
Recommended Products
