Your cart is empty.
Your cart is empty.
Applications The anchor is made from ZAMAC.
This anchor is designed for use in Concrete, Block, and Brick.
Environment
The anchor is designed for use in a Dry environment.
Hole Diameter/Bit Diameter
The anchor requires a 1/4" hole to be drilled in the base material (Concrete, Block, and Brick).
The hole should be drilled with carbide tipped bit that meets ANSI standards and used in a hammer drill.
Diameter of Anchor
The diameter of the anchor is 1/4".
Minimum Embedment
The minimum anchor embedment into the concrete is 3/4".
Therefore, the anchor must be installed so
that a minimum of 3/4" of the anchor is embedded into the concrete.
Spacing between Anchors
Each anchor must be spaced a minimum distance of 2-1/2"
from each other when measured center to center.
Edge Distance
It is very important not to install the anchor any closer than 1-1/4"
from an unsupported edge of the concrete.
mike osip
2025-07-23 17:54:02
I'm so happy with it it made me go out and get drunk
Lonnie
2025-04-24 14:07:52
They will make good anchors for the wood on top of my rafting trailer to secure the wood flooring down.
Mimi
2025-03-12 18:54:24
Not strong enough ..
Recommended Products
