Your cart is empty.
Your cart is empty.Product Description
Public Profile Name
July 9, 2025
Having never used this kind of drive belt I had my doubts that cutting, heating, and squeezing together a polyurethane spaghetti noodle would actually work, but it does. I used a hot air soldering station to heat the ends, pushed together, held for around a minute while blowing to cool the new joint, then used my smallest pair of flush cutters to trim the joint round again. It may take a few tries to get the right effective length, make a good square cut, and join the ends in perfect alignment, so plan to toss one or two as part of the learning curve. The finished joint is shockingly strong, and seems no more likely to come part when stretched than the rest of the belt material.This saved me from having to spend $60 to buy a single belt for a thermal ID printer.
jason kanagy
June 22, 2025
It was easy to use and held up to expectations
Jolene C.
June 13, 2025
I tried everything to get this to stick together and to know avail. I'm glad I only bought a foot of this junk. Don't buy it
robert volaski
May 11, 2025
excellent product I use this belt on my watchmakers lathe very easy to splice together and its very quite .
Customer
December 19, 2024
I used this on my Singer sewing machine to replace the crappy rubber belts you get for the electric motor
Recommended Products