Your cart is empty.
Your cart is empty.Harmonic Balancer Puller Crank For GM 1997 LS LS1 Engines, Crankshaft Installation Crank Pulley Installer.
Flash
2025-08-29 14:32:59
Worked very good happy with it
Jesus vazquez
2025-08-12 16:38:09
I fix my Chevy 5.3 2006 with this bolt, I put it on the harmonic balancer and works perfectly 👌👌
jon
2025-08-09 21:56:02
It's somewhat but not perfectly straight.Does the job if you're careful enough.Material is soft so you may only get a couple uses out of it
p
2025-07-26 16:35:07
Installed an aftermarket harmonic balancer on a '98 corvette without any issues.
A Spirlark
2025-06-25 17:46:16
This was used to install an after market ls balancer that required a super long balancer bolt.
sergio saucedo
2025-04-14 15:37:00
Worked great! Good for the money, used on lq4
Jason lulgjuraj
2025-02-09 10:33:04
Worked good installing a lsa balancer 2 times Not hiccup
S. Snively
2025-01-21 14:21:56
It seemed like it was up to the task of installing a harmonic balancer, however, upon first use the lower bearing race snapped in half. 89 ft/lbs was all it took and then snap, that’s not even that much when it comes to crank bolts. The washer under the race also seems a little small and may not cover enough of the balancer. I can update this review if they choose to send me a replacement but it’s outside the amazon return window so I doubt they will reach out to remedy it.
Recommended Products
$22.28
$ 10 .99 $10.99