Your cart is empty.
Your cart is empty.6 X 5 X 4-1/2 Open End Slotted Angle Plate ~ Convenient clamping slots for mounting. ~ Widely used for machining, layout and inspection. ~ Made of high tensile cast iron properly seasoned against distortion. ~ Accurately machined to .002 per 6". ~ Square and parallel on all faces. ~ Slot A is 90° to slot C.
Ben Wilson
2025-08-11 09:12:50
There were still some burrs on the edges, but the important faces are clean and square to each other. I would happily buy again.
Steve
2025-08-05 16:02:30
A little rough grinding and burrs around the edges, but otherwise pretty good. I may scrape it in later.
George Knowles
2025-08-02 16:32:03
As is out of the box ...The working faces all have burr edges akin to a woodworking cabinet scraper.Both the face and back side of all the slots have pronounced burr edges that are scalpel sharp.These may work for the hobby machinist willing to invest a fair amount of time in cleaning them up.They’re no bargain if you’re paying an employee machinist wages to make them safe and useable.
lar ya
2025-07-15 16:00:05
This angle plate was well packed and padded. The metal is rough on the inside surfaces, but smooth where it is needed to be. All edges and slots did benefit from deburring and sanding. My test indicator has a .0005" resolution. The needle moved about half of that while measuring vertical accuracy. This angle plate suits my home-hobby machine shop!
OverClock
2025-06-24 15:47:36
Great value, nice sharp corners, would buy again.
Mark Savoca
2025-06-15 18:26:16
Flat surfaces, clean edges, works as expected.
Reinventing The Steel
2025-05-25 10:19:08
The angle plate only has a fraction of the slots its supposed to have. As the pictures attached show, the plate only has a total of 5 slots in it, as opposed to the 12 slots its advertised as having. The additional slots that are missing are crucial when needing to fixture oddball sized and shaped parts. The plate also arrived with several gouges and dings. After sending the angle plate back and asking for an angle plate with the proper amount of slots in it, I received yet another that also is missing slots. This is extremely sloppy manufacturing and quality control. Buyer beware.
Elizabeth Darling
2025-05-10 12:36:52
Work great as a small angle plate inside my CNC machines
Georges
2025-02-12 14:14:29
Alles oké
Joel S.
2025-02-07 15:44:45
The angle plate in the picture has a ton of slots; 5 on top and 7 on bottom. They include dimensions of these slots in the diagram. This is a lie. This is not the angle plate you will receive.The angle plate you'll get has 3 slots on top and 2 on bottom. Also it's crazy sharp. This has not be deburred. The build quality in general is poor.AVOID.
Recommended Products
$14.99
$ 6 .99 $6.99