Shopping Cart

Your cart is empty.

Your cart is empty.

HHIP 3600-0056 End Mill Grinding Fixture (Angle) 5C

Free shipping on orders over $29.99

$89.70

$ 43 .99 $43.99

In Stock

About this item

  • Solid negative ball stops with 15 degrees spacing fast & easy set-ups.; Can be used for grinding 2-3-4-6-8 and 12 flute end mills
  • This fixture takes 5C round collets for grinding end mill 1/16" ~ 1-1/8" .Clearance & relief angels are built into the base
  • Shell mills can easily be held with Straight Shank arbors
  • Clearance & relief angels are built into the base


This fixture takes 5C round collets for grinding end mill 1/16" ~ 1-1/8" . Shell mills can easily be held with straight shank arbors. Solid negative ball stops with 15 degrees spacing fast & easy set-ups. Can be used for grinding 2-3-4-6-8 and 12 flute end mills. Clearance & relief angels are built into the base. Solid 2-1/2" x 4-1/2" base bottom Ground for sure contact. Black oxide finish. 5C collet not included.


Toby T.
2025-08-19 11:50:12
Takes a few minutes to set up but saves money in the long run
Pavel Fernandez
2025-02-16 19:26:37
GOOD