Your cart is empty.
Your cart is empty.This fixture takes 5C round collets for grinding end mill 1/16" ~ 1-1/8" . Shell mills can easily be held with straight shank arbors. Solid negative ball stops with 15 degrees spacing fast & easy set-ups. Can be used for grinding 2-3-4-6-8 and 12 flute end mills. Clearance & relief angels are built into the base. Solid 2-1/2" x 4-1/2" base bottom Ground for sure contact. Black oxide finish. 5C collet not included.
Toby T.
2025-08-19 11:50:12
Takes a few minutes to set up but saves money in the long run
Pavel Fernandez
2025-02-16 19:26:37
GOOD
Recommended Products
