Your cart is empty.
Your cart is empty.Hardened And Ground for Single End Mills Only.
L Holman
2025-09-04 10:24:03
Good price and good quality.
Vince B
2025-08-10 09:17:41
Tool feels and looks just like the 70 dollar version from bigger name tool houses. Spins true and works as advertised. Was a little nervous with it being 30 bucks. Very satisfied with the chance I have taken on this. I use it to spin a 1.5in indexable tool for facing.
Jut
2025-07-18 09:46:40
Nice fit and fast shipping
mike44
2025-07-15 20:15:05
received the endmill holder and have not yet installed it. Looks like a quality tool.
Customer
2025-07-09 18:33:56
good for hobby machining
James I. McLallen
2025-06-22 18:17:07
These work well although one of the holders seems to be too small. It seems to be off by a few thousandths of an inch. I should be able to lap it with valve grinding paste to make it work.
Chris
2025-05-18 09:11:48
Great value for the price. Holds tight tolerances on both roughing and finishing processes.
GLB
2025-04-21 11:20:10
the end mill shank slide in perfectly-- almost creating an air-tight piston... Two set screws matched my end mill flats' position too. Fit in the R8 spindle fine too.
Customer
2025-03-15 11:29:00
It works well, but I had to use a tap to remove burrs
Davila
2025-02-12 13:41:12
Cumple con los requisitos
Louis
2025-01-27 17:40:26
Good set, I use them un my milling machine.Fit is good and no runout as far as I can tell.I can leave the tools in them unlike r8 collets, this makes a quicker work!
N. Prescott
2025-01-15 12:35:14
Really solid end mill holder. Replaces one of the alternate types that proved way to weak and flexible in use.
Dave in Calgary
2024-12-08 16:58:52
this piece does not accept 1/4 inch end mill bits. The hole size is much closer to 6 mm. While the tool can still be used, it is disappointing that it is not the correct size as promoted.
Recommended Products
$76.99
$ 35 .99 $35.99