My SRM210 was new before ethanol mixture became 10% (or more) by federal regulation. We Virginians got a bad mixture one summer where the blend was "accidentally" 22% across the commonwealth (documentation can be found by looking up the lawsuits filed) and my primer bulb, fuel lines and carburetor all had to be replaced that summer. The dealer wanted an arm and leg for them but I had no choice but to pay the fees or buy another trimmer. Fuel stabilizer helped the replacement last 7 seasons but I knew at the end of last season the carburetor was about shot again but forgot all about it over the winter. I got 2 trimmings this spring and on the third I was able to gimp it through by holding it just right, holding the throttle just right, holding my tongue just right and what usually takes about an hour to trim took about 4 hours. I don't have time this week to get to my local dealer so I figured I'll try Amazon so I can get it shipped to my house instead. I was amazed at the price difference, so much so I thought it was too good to be true.It took about 15 minutes to get everything changed over (I didn't change plugs because it's a no name and my other is less than a season old) and after pumping the bulb enough times to fill it with gas it started on the second pull. It's been a LOT of seasons since it did that. It ran very well for about a minute then acted like it was out of gas. I filled the tank the rest of the way ( Exxon gas is only about 2 weeks old and has marine grade fuel stabilizer mixed in ), fired it up and other than at full throttle it ran like a new trimmer. A slight adjustment of the high adjuster and voila, great to go.Other than the body and shaft looking its age I feel like I have a new trimmer and got the whole kit for about 1/4 what I paid for just a carburetor last time . Time will tell if it lasts 7 seasons like my last one but for the price paid if it lasts 2 I'll be happy. It said in the description it's made for 10% ethanol mix but the gas lines look like they're not going to hold up too long, no biggie as I've got a few feet of a higher grade in my shed if it wears out. So much has changed since the unit was new the cheaper looking line might actually be better than the semi clear/thicker od I've got on my shed. Again time will tell.If you can turn 2 bolts (loosen, tighten) and put the throttle cable on after taking it off the old you can save yourself a ton of money and time without your trimmer and replace it yourself in under an hour. There's probably a YouTube out there if you have trouble with any of it, including adjusting the fuel mixture of it runs wonky after changing it.Great fit, great price.

OK so today is July 7th and I just received my Hipa Carburetor kit. I got home from work and I was excited to see that it had arrived. I went to the backyard and installed it. It took me around 15 minutes because I had forgot how to remove the wire that goes on the little screw on the carburetor. I had to stop and watch a youtube video on how to do it. After I install the wire, I then installed the fuel line. Then I attached the hoses, then the gasket, then the two screws, then the air filter, and the air filter cover. I then pump the primer bulb and wholaa I see the gas pump right in. OMG!! I haven't seen that since I bought my echo trimmer 5 years ago from home depot. It started on the second pull. I was like whaaattt!?? This thing rocks!! So let me tell you something. On saturday July 2nd, I had went to home depot and i purchased all of the echo orinal parts. I got the air filter, the spark plug, the fuel line and the primer bulb. I was just going to buy the primer bulb because that was the only thing broken but i decided that i might well just do a tune up because i never did any maintenance since I bought it. I got home and after installing everything the stupid primer bulb wasn't filling up with gas. I did so much research on the internet and try so many variations but still no luck getting gas into the new install primer bulb. So I went on amazon and saw this entire carburetor kit. Ok so check this out. With all the parts I purchased at home depot it came out to $55 dollars. I went back to home depot and got a full refund. I got home and decided to buy this Hipa carburetor kit based on all of the excellent reviews. I am so glad I tooked a chance on this. And I only payed $26.12 total with tax and shipping included! And now my trimmer in running like new. The reason why the primer bulb was not working must of been because one of the little valves inside of the original carburetor was clogged or not working properly. I wasn't going to open that up way to complicated. Let me tell you that when I went to home depot to get a refund for all of the echo parts I had purchased, I almost ended up buying a new trimmer. I was like well, my echo trimmer lasted me 5 years, now bad for $150 investment I might just well buy another one. But then I stop and decided to go home and do more research on how to fix it and I am so happy that I purchased this Hipa Kit because it works flawless. I went to the backyard and front yard and trim all of the edges. After I finished my hands were shaking for like 20 minutes. I remember that feeling a long time ago when it used to work like new. Now my Echo GT-200R is running like brand new and I can't wait for the grass to grow to trim again. The only thing I need to worry about now is buying a faceshield because the safety glasses i have only protect my eyes but when i trim i get hit in the face and it hurts. Also I am going to do research on buying a really strong trim line that doesn't break easily so I don't have to be changing the line over and over.Anyhow, thank you Hippa for making this awesome carburetor kit. You save me soooo much money and I felt happy changing this myself.You rock!!! 5 HUGE STARS FOR YOU!!

All the items included in this kit seemed well-made and all fit perfectly. I rebuilt a neighbors weed whacker completely. It started first pull after the rebuild. I Recommend this company for excellent service, excellent products and very reasonable pricing.

Never disappointed with these carbs. I have purchased many from this supplier over the years.

I have an EchoGt200-r that was sitting in a storage shed for over 12 years without being run. Overall, the fuel lines were cracked, the primer bubble was dried and broken, filter was nasty. I didn’t think the weed trimmer would ever work. However, I thought I would try this replacement kit and I am shocked… not only did it work but the weed trimmer runs better now than when I originally bought it. Attaching everything was relatively easy. It’s just the best thing ever… especially if you’re mechanically inclined. Highly recommend!

fit perfect, hedge trimmer started on first pull and still running perfect today.